Question about Insignia IS-PDO40922 Portable DVD Player

4 Answers

PICTURE JUMPS AND SHAKES

CD LOADS AND PLAYS BUT PICTURE JUMPS AND SHAKES ON THE SCREEN.

Posted by Maria ALba on

  • kksmom Jan 21, 2008

    Mine does the same thing. It is with all dvds. It will jump and shake into a black and white screen about every 60 seconds. Do you know of a solution to this problem?

×

Ad

4 Answers

Anonymous

This happens to me when the battery life is dead. Try restarting it with the power cord plugged in.

Posted on Feb 08, 2007

Ad

Paul Farrar

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

This player will play PAL as well as the US NTSC standard. Cycle through the PAL/NTSC button.

Posted on Jan 13, 2007

Ad

Anonymous

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I'm having a similar problem with my Denon DVD-756 player. It happens only when connected via the component video route (it works fine with s-video). I'm not sure what the solution above is talking about when it says "this is supposed to be common with all portable players" as that makes absolutely no sense here. This is a $400 Denon home dvd player, not some $50 portable player from Walmart. Any helpful suggestions would be appreciated though.

Posted on Jan 13, 2007

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 513 Answers

This is supposed to be common with all portable players, but only with certain discs. Are you getting this on all discs, or just on some? Good luck

Posted on Jun 04, 2006

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My Sony mini hifi component system is going berserk!! 2 problems: 1- CD system skips tracks and on playing on repeat song, the song skips certain times and jumps ahead of the track. 2- Tape system plays...

Your cd player is fubar and in definite need of replacement.
Tape unit seems to have a mind of its won. Try to reset the electronics to factory defaults. If that has no remedy, since it is a sony< best advise is to trash it. Repair cost is prohibitively expensive.
0helpful
1answer

Jumping picture on playback on TV DVD player

Hi,

Try using another brand of DVDR (cheap ones tends to cause porblems in regular DVD players) and burn at a slower speed.
0helpful
1answer

Panasonic SA-PM19 5 disc player jumps around, starting at or near first track, plays a little, then jumps a good chunk, plays a little more etc, until it reaches (quickly) the end of the disc. It does this...

Could be a CD defect, but probably just dust inside. Try canned air, or connect IPOD after you convert CD's to MP3's or other player to AUX port as a connector as a work a around. Splicers available online if you already have a TV connected.
1helpful
1answer

Screen shakes / jumps vertically on my Sony KP-51HW40

The jitter is called a vertical sync problem. The problem is on the "A" board. It can be replaced or rebuilt but will be quite expensive to service.

michtech
0helpful
1answer

Jumpy picture

ck for dry solder joints if you take rear cover off and just lightly tap on convergence ic heat sink if the tv jumps then you have to remove the board and resolder the joints. also if you have a magnifying glass ck all solder joints on board when it is out
0helpful
1answer

Videos (like on youtube) stops after 2 seconds and reloads

this is not your monitor problem this is your system CD Drive lens so plz check drive and clean cd lens
plz call 09944377607
1helpful
1answer

CD won't play; continually shuffles from one CD to another

did it just start doing this....how long have you had the unit for?
0helpful
1answer

Picture jumps or shakes

possible solder connection breaking down when the set is cold.look in and around the horizontal and vertical section for cold solder connections.
0helpful
1answer

Lg external dvd burner

Could you give me some detail on the operating system, Direct X version, and if your using USB , or USB 2.0 ?
0helpful
1answer

Insignia dvd is-pd040922

I have the same model of DVD player and sometimes that will happen to me, and when it does I will move the screen up and down, and the picture always comes back for me, you can try this but I dont know if you have the same problem as me.
Not finding what you are looking for?
Insignia IS-PDO40922 Portable DVD Player Logo

379 views

Ask a Question

Usually answered in minutes!

Top Insignia Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76758 Answers

Cindy Wells

Level 3 Expert

6352 Answers

Ekse

Level 3 Expert

13435 Answers

Are you an Insignia Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...