Hi,
Your camera's firmware is corrupt and need to be updated. The following are available updates for your camera. These are not links. The link to these drivers are below the list:
http://www.fujifilm.co.uk/consumer/digital/digital-cameras/legacy-cameras/finepix-f402/support
anaanymous
Hi.
I think there is a problem with the connection to memory device in the camera as you can review but not record anything.
Possible cause could be that the connection to certain features has been affected.
If you can use certain features it means there is not a major fault but a minor one.
I advice you to take the camera to a nearby repair shop to get it checked.
Hope this helps
Regards
Faraz
Inside the door hinge area is a small switch that normally would turn off the viewfinder and turn on the LCD panel. THat switch could be defective or mechanically not being switched. WIthout opening up the unit, I can not tell specifically. This shouldbe a simple repair for any shop that repairs cameras.
93 views
Usually answered in minutes!
the only door on the f402 is where you insert the battery and i cannot see any switches
sounds like i have to send the camera off to fujifilm thanks
×