Question about Sony KP-46WT500 46" Rear Projection HDTV-Ready Television

Open Question

Sony KP-46WT510 has flashing 6 times. Will not turn on, What can i do to fix this problem

All i can find on the internet is C 515 & C516 : IC 206 (jungle) i can not located these components in the back of the TV Can you help me

Posted by Alicia on

Ad

5 Related Answers

Anonymous

  • 105 Answers

SOURCE: Convergence problem

you will need to replace the stk ic's they are mounted to 2 large heat sinks in side the tv. the ic numbers are on the chips themselves. i do believe it is stk392-510 for sony. once you have the number you can buy these anywhere online. just put new ones in and should be good to go. if this doesnt work then there are a few resistors and fuses by the ic's that sometimes fail.

Posted on Oct 12, 2007

Ad

Anonymous

  • 306 Answers

SOURCE: Sony KP-46WT510 - Six Blinks

the deflection board is bad and they are real easy to replace...contact the manufacturer for the parts.

Posted on Jan 20, 2008

Ad

Anonymous

  • 1 Answer

SOURCE: sont kp-46wt510 blinks 4 times

Could you send the service manual to me as well? Any idea what this might cost to fix? Thanks
email: [email protected]

Posted on Feb 13, 2008

Anonymous

SOURCE: SONY KP-46WT510 WITH 6 BLINKS

sorry i couldnt have been more help. glad you figured it out.

Posted on Feb 27, 2008

Slinteriors

Sonny Berry

  • 8617 Answers

SOURCE: Finding the convergence ic's

They are located on the D board attached to large aluminum heatsinks They have the numbers STK392-560 you will need to replace both of them. You can get new ones at this link and they will give you free installation instructions with free tech support to help you with doing the repair. here is the link.
http://servicemanuals.vstore.ca/

Posted on Apr 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blinks 6 times. i go into self dia. under 6 it has (bat low)


i think it B+ low voltage error
usually a 6 or 7 blink will be a bad IC, its like IC8002 I think, atleast on the smaller tv sets, its a 12 pin IC
looks like the # is MCZ3001D or MCZ3001DB
they'll usually be intermittent and eventually fail

Jun 22, 2010 | Sony KP-46WT510 46" Rear Projection HDTV

2 Answers

Try to turn on, it turns off right away and the stand by light flashes 6 times


Hi


Thanks for using FixYa. Standby/Timer light blinking 6 Times means no Horizontal (H STOP), no raster, and so the set goes to the blinking self-diagnosis function immediately. You’ll need to open the back off the TV and check C515 & 516 and the jungle IC, IC206. Also check +5 line is overloaded (A, B boards), +5 line is shorted (A, B boards). Please do rate the solution if the issue is resolved or post a comment for further assistance.



Thanks
Rylee

Jun 03, 2010 | Sony KP-46WT510 46" Rear Projection HDTV

1 Answer

Sony model KV32hs420 Powers on for 2 seconds than turns off and standby light flashes 6 times


you have no horizontal output,with a ohm meter check C515 & C516, also check the jungle IC,IC206......... hope this helps.

Feb 16, 2010 | Sony Televison & Video

1 Answer

Sony FD Trinitron WEGA KV-30XBR910 30" TV Led flashing


6 blinks meens no horizontal and no raster check capasitor c515/c516/ jungle IC and IC206.
regards,
daniel.

Dec 28, 2008 | Sony FD Trinitron WEGA KV-30XBR910 30" TV

1 Answer

Sony KP51-HW40 Rear Projection Tv service manual


6 blinks on sony Check c515 and c516 and the jungle ic IC206.

Dec 22, 2008 | Sony KP-51HW40 51" Rear Projection...

1 Answer

6 bliks on sony kp-46wt510


KP46WT510 Shutdown 6 Blinks. 6 Blinks = Low B+ OCP/OVP
SOLUTION: Replaced Flyback transformer. It had no rings on the ringer test.
HQ
Comments: Any load on the B+ line can cause 6 Blinks.
Example: If the 200v line is loaded down will cause a drop in B+ due to bright picture current demand.

Click Here! to download the Sony Kp-46wt510 full service manual.

Nov 11, 2008 | Sony KP-46WT510 46" Rear Projection HDTV

3 Answers

SONY KP-46WT510 WITH 6 BLINKS


IF I REMEMBER CORRECTLY THAT IS A LAMP THRMOSTAT

Feb 22, 2008 | Sony KP-46WT510 46" Rear Projection HDTV

1 Answer

Convergence problem


you will need to replace the stk ic's they are mounted to 2 large heat sinks in side the tv. the ic numbers are on the chips themselves. i do believe it is stk392-510 for sony. once you have the number you can buy these anywhere online. just put new ones in and should be good to go. if this doesnt work then there are a few resistors and fuses by the ic's that sometimes fail.

Oct 11, 2007 | Sony KP-46WT510 46" Rear Projection HDTV

3 Answers

Sont kp-46wt510 blinks 4 times


Four blinks is a "vertical stop error" I have a pdf file of the service manual and troubleshooting guide. If you want it,let me know where to send it.

Sep 27, 2007 | Sony KP-46WT510 46" Rear Projection HDTV

Not finding what you are looking for?
Sony KP-46WT500 46" Rear Projection HDTV-Ready Television Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76407 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...