Question about Bosch Axxis WFL 2060 Front Load Washer

2 Answers

Washing instructions What are the three receptacles found in the drawer on the left side of the washing machine?

Posted by anniniou on

  • pompqueen Oct 12, 2008

    Yes, I know the three cups on the left of the Bosch Washer are for detergents/softeners/bleach, BUT WHICH ONE IS WHICH????



2 Answers


  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

My book says for the Axxis WFL 2050/WFL 2060 : from the left while looking at it from the front: detergent for wash, stain remover, middle: fabric softener, fabric conditioner, right one: detergent for soaking agent. (Do not use chlorice bleach in this wasking machine).

Posted on Nov 03, 2008



  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 2,712 Answers

Thats where you put the detergent and fabric softener, etc..

Posted on Oct 12, 2008

  • Margareth Oct 01, 2019

    Ok so what on earth is a Soaking Agent?? Do they mean plain washing detergent? So yhen do you put the detergent BOTH in the receptacle for Soaking (on the right), AND some detergent in the left receptacle? If not, WHAT IS A "SOAKING AGENT"???



Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Dispenser fabric softener slot

Fabric Softener Compartment Full Of Water - White Goods ... > ... > DIY Washing Machine Repair Help
Jul 9, 2013 - The small fabric conditioner compartment in the soap dispenser drawer has a plastic cap or tube at the back for the water to siphon up through. ... Make sure the washer is level front to back as well as side to side. .... If the washing machinehasn't been used since there's always the possibility that the plastic ...

The fabric softener part of my washing machine drawer keeps ... > Topics > Housekeeping

MumsnetAfter each wash, the fabric conditioner part of the drawer is f. ... The fabric softener part of my washing machine drawer keeps filling with water ... Stopped using thedispenser compartment for fab softener and instead did I separate ... see if that clears it up and also try cleaning behind the drawer in case there is a blockage.

Washing Machine ' Fabric Softener ' Problem ' Won't Empty

Jan 16, 2016 | Washing Machines

1 Answer

I have a whirlpool cabrio washing machine.ecerything is working fine but its beginning to smell like sewer. The sink next to it doesn't smell nor the drains. It's coming from the washer. Anything I ca

Clear your filter.
Remove detergent drawer and clean the drawer and its receptacle on the machice.
Bung in 8 milton tablets in the drum and put it on the hottest longest wash you can and leave it run normally.

Run a short cold wash to flush the machine

Now put some nice smelling low foaming disinfectant in and repeat the hot wash cycle.
This should sort it but may take repeated treatments. Lower the amount of softener and detergent you use as excess can build up and can cause this problem to come back. Additionally dont overload with really dirty cloths and if you do a wash with exceptionally dirty cloths then after you empty your machine put it on a shortest rinse cycle to purge and contaminated water that is left behind.

If all this fails you will need to have your machine serviced.

Oct 03, 2012 | Washing Machines

1 Answer

Which of the three sections in the dispeser does the fabric conditioner go in?

If you pull out the dispenser drawer, there are usually three sections to it, the fabric conditioner one is usually on the right hand side if it is a U.K model, but other countries may vary. It will be the smallest and should have a kind of grid covering it, whereas the others will be open. If you have the instructions for the machine, it will state exactly, but I'm guessing that you don't, or you wouldn't have asked!

Aug 23, 2011 | LG WM-2277HW Front Load Washer

2 Answers

OPEN TAP message is displayed and the machine will not work

Instructions from Capresso:
-pull out the drawer
-look inside the unit where the drawer has been removed and look for a flap (it's really the first thing you see on the left side)
-without moving the flap, reach your hand under it and up until you feel a flat surface
-this surface will have grounds on it
-feel for screw in middle
-take paper towel and wipe off grounds
-repeat until paper towel is clean
-replace drawer and done!
-do this about once a week to prevent this

Jun 25, 2009 | Jura Capresso Impressa E8 Espresso/Coffee...

2 Answers

My Zanussi ZWF1430W won't take fabric conditioner from drawer - it washes and spins okay on all programmes.

Sometimes the drawer gets blocked with congealed fabric conditioner and or old soap powder, try removing the drawer and giving it a good wash. An old toothbrush is useful to get in the small areas. To remove the drawer: Pull the drawer out as far as possible, there is a small depression on the left hand side at the top of the drawer, about the size of a fingertip press the depression to release the drawer, and pull the drawer out. To relocate, line the drawer up, and place the long thin piece of plastic on the left hand side in the corresponding slot in the top of the drawer opening, you might have to kneel down to see it and slide the drawer in, you might have to press the depression again to pushe it home.

May 04, 2009 | Zanussi ZWF1430W Front Load Washer

1 Answer

ASKO 6021 washing machine, drawer locked

Reach under the drawer, right side and move the lock mechanism to he left. The drawer will unlock.

Mar 22, 2009 | Asko W6021 Front Load Washer

1 Answer

Not working

Three possible causes.

1. The drawer where the coffee grounds end up is not properly inserted. To fix insert drawer completely.
2. The tab on the left side of the drawer is broken off. To fix purchase an new drawer.
3. The drawer microswitch has a problem. There could be many reasons for this. The machine will have to be opened up to see whats wrong.

Dec 02, 2008 | Saeco Royal Digital Plus Coffee...

1 Answer

My 7 year old Samsung Sensor Quick P1003J has been leaking (on and off) on the left side near the front just below the detergent drawer for sometime now. A repair man never found the cause. Even changed...

there is a hose from the soap drawer to the tub and this can leak. also it can be the soap box leaking. take out soap drawer and clean box and drawer. also try tilting machine back a little

Nov 15, 2008 | Samsung Washing Machines

2 Answers

Whirlpool duet washer leaks from detergent drawer when filling with water

We just had the same problem. We took off the three screw on the back to remove the top panel on washer. From there we took the screws off the electric face plate on the front. Be careful, there is a screw located inside the door. You must open the door to get to the screw. Next we removed the bottom panel door and then the four screws to the mail metal panel on the front. Hold that panel because the rubber gasket is still connected. Then you will see a rubber hose directly under the drawer. Take the rubber hose off at the bottom nearest the drum. We found a sock that had wedged itself up and was causing a back up. After I cleared it, the washer works just fine.

Aug 08, 2008 | Whirlpool Washing Machines

1 Answer

Whirlpool duet washer model GHW9400PWO

Removing the Washer Top
Three screws secure the washer top at the back of the washer. Remove the three screws and lift the top from the washer.

Removing the Console from the Cabinet
Disconnect the Touch Pad/LED Assembly ribbon connector from the left side of the Central Control Unit and release it from the wiring harness brackets on the right side of the washer top

Remove the detergent dispenser drawer by pressing down on the release tab at the back of the drawer and pulling it completely out of the washer.

Once the drawer is removed, remove the screw in the recessed hole next to the drawer opening. Release the tab securing the right side of the console to the washer

Open the washer door and place a flat-bladed screwdriver into the slot in the bottom center of the console. Push the console up to release center console tab. Be sure the ribbon cable clears the cabinet frame.

Removing the Touch Pad/LED Assembly from the Console
The Touch Pad/LED Assembly is removed as a single unit and contains the Push Buttons, LEDs, cable, etc. The buttons can be replaced separately

Jun 28, 2008 | Whirlpool GHW9400 Duet Washer

Not finding what you are looking for?
Bosch Axxis WFL 2060 Front Load Washer Logo


Ask a Question

Usually answered in minutes!

Top Bosch Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8221 Answers

Brad Brown

Level 3 Expert

18666 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Are you a Bosch Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides