Error code p03 - Office Equipment & Supplies

Question edited for clarity.
Question moved from Washing Machines to Forklift.

They are both ECM Communication errors.

Forklift error codes for Nissan - Warehouse IQ

https://www.warehouseiq.com > nissan-forklift-error-co...
Nissan forklift error codes ; F01, Memory check error ; F55, Tilt forward solenoid error ; P03, VCM communication error ; P04, ECM communication error.

https://www.google.com/search?q=Nissan+lift+F04%2C+P04+code

..

Question edited for clarity.

Lots of videos on this error.

https://www.google.com/search?q=p03+in+canon+g2010+printer

..

Question edited for clarity.

Error codes carry to all Riso machines.

Error Codes > Riso > KZ30 > Code P03 - PrintCopy .info

https://printcopy.info > brand=Riso
Riso KZ30. Service manual. Error Code: ... 502 Clamp sensor does not go ON within 2.5 seconds from the time the clamp motor operates.

https://www.google.com/search?q=riso+200ez+P03

..

Hi,I cant be a hundred percent shore,but I think that it means ( fuel voluem regulater control curcuit low )I hope I am not steering you in the wrong direction,I have a code gide and this is it if im reading it write,all the best.

Look in the instructions to find out what the button press sequence is to reset the printer.

Download the manuel from this link below:http://www.manualowl.com/p/Canon/PIXMA-MP495/Manual/68096

It might have some trouble info for you. ;-)

Error code PO3 is caused by Timing Disk dirty / damaged.
Please use this methods
1. Check the timing disk sensor located to the left of the printer
2. Check and clean the board.
And start to print... thanks

manual replacing the print cartridges --> try rotating the left white gear back and forward releasing the mechanical lock of the print head it is a small plastic peace in the back of the of the head ...replace the cartridge as you need ...


about the error p03 it indicates a mechanical jam (head carriage - paper jem - paper pickup mechanizm - head cleaning mechanizm ) also clean carfully all sensors from inside ... it can give you a mechanical jam if blocked

If this is a Xerox 128, I have looked through all the documentation and those are non standard fault codes.
I would first start by seeing if the scanner was comming on and moving correctly.
The only other thing you can try is to remove all the covers and disconnect and reconnect plugs, and ribbon cables.
There is nothing in the documentation or engineering notes to reference any of those error codes.
Not even eliminating the P and just looking up the individual codes as just numerical codes.
A non functioning scanner will produce many odd codes not listed in documentation, which is why I am having you start there. Reseating connectors will allow all modules to communicate, which can also produce odd codes.