Error Code "L" 0n Sharp AL 1540CS

Do you mean the Sharp AL-1540CS? If so, this unit does not make color copies. It is a monochrome all-in-one laser printer. The manual for the Sharp AL-1540CS is available from ManualsLib here: https://www.manualslib.com/manual/151265/Sharp-Al-1215.html#product-AL-1540CS . The replacement toner cartridge is the AL-110TD, a 4000 page Black toner. See https://www.manualslib.com/manual/151265/Sharp-Al-1215.html?page=72#manual for the supply list and accessories.

When you scan a document with the AL-1540CS to your computer, you can print the document in color if you have a color printer.

I hope this helps.

Cindy Wells

This is a critical issue which needs constant monitoring of the device and continuous chat / email exchange.

Thus it is advised to please avail paid fixya services for better support and quick solution.

Thanks

Hi Dave,

E7 means that the lamp under the glass is not working.The most common cause is a blown fuse that sits right beind the lamp.If you can test the fuse and take it from there.

Hello sir; I like you check the scanner unit, the mirrow does move out when you make a copy, you may easy to find out what cause the mirrow not move out.

CH code on a Sharp usually means the front door or a side door is not completely shut. Try opening and closing every exterior door until the code goes away. If the CH is flashing, it could mean either an optical or a heat roller fuse might have blown. Have you recently replaced any supplies?

Manual says F5 as copy lamp lightning abnormality.
Never had on AR series Sharp machines this trouble,but remember on old Canon NP 6016 when lamp was bad -no dark ends and low intensity of lightning but intensity too high.This machine was equiped with doc feeder and customer performed a lot of copies from glass only and I think he was damaged lamp when close the doc feeder.
the fluorescent type lamp was used on this Canon-Sharp uses Xenon lamp (I think),but they could be very common in construction (tube with electrodes on ends and gass inside)
This fault is very difficult to troubleshoot-try another lamp first,next sensor from good working machine.

Its supposed to reset itself without a service code. If it isn't let me know.

i have al-1540cs and it if flashing H then 4

there is a lock on the left hand side ... make sure it is in the unlock position.

On my SHARP AL-1540CS printer 4 and H blinks alternately and none of the buttons except power is working.