E6 fault unable to reset all cycle lights showing

Whats the make & model of the washer?

The E6 error is telling you that the clutch is causing the error or fault. This fault can happen if a paperclip, nail, coin, or a different object is jammed in between the tub and pulsator.

U shud shut it off daily for rest lika computr or fone

I had that b4 and it was the ribbon cable. Disconnected and reconnected and was clear after 60s reset cycle.

Not sure of the make/model, but with Samsung washing machines that usually means 2 things. If you get it when entering the spin mode and the system stops and displays the code, the water heater is heating too quickly. Press the power button once to clear the code and finish the cycle before repair.

If you get the E6 during the spin cycle that can mean a problem with the main controller board.

You can keep resetting to get past that code but if you continue to get it during a spin cycle or part of the laundry where hot water isn't used, then usually that controller board is bad.

Good luck.

Hi
I got the E6 error at the end of cycle and inside it was exceptionally hot and dry, no leak under DW,
I put breaker off and error was persistent, it finally disappeared after a moment, I guess after temperature went down.
If it happens again I'll update the topic.

F7 E6 shows that Function pad button stuck or Bad clock try to Unstick Button or Replace Clock also if persist then check the connections to the contol panel

the memory card automatically locks wen u insert in the phone...
go to moto service centre

what does E6 error stand for

There's an active virus inside your memory card in which they can't reformat and unable to show in the window. try to scan it on your antivirus. try the kaspersky anti virus.