Brand new oven, maytag, the oven won't heat up and

I think your ignition does not work.
Is this a brand new oven ?
Does it have a stove on top ?
does the stove work ?

Display on maytag oven 8114p471-60 went blank - Fixya

www.fixya.com/.../t16018814-display_maytag_oven_8114p471_60_we...

Jan 20, 2013 - Stove top electric ignition still works fine, so there is power going to the .... maytag cwe4800acb oven shuts off and display goes blank during .

Dont use it! You need to pull the cooktop and see what is wrong. There is a chance that the circuit for the surface light is the only standing circuit left because the heating element is bad or loose

This tutorial will show you how to check your Smeg element and how to replace your Smeg cooker element.
Here are the 3 main faults to look for in your oven or cooker that is not heating

• Your oven will not work until the clock/timer has been re-set after replacing an oven element or tripping the electrical supply. Consult your Smeg manual.
• If your Oven is not getting hot or heating up it could be a faulty element, if the fan in the oven is running and the thermostat light is on, this will lead us to believe that the element has gone faulty. With grills the thermostat light should come on there should be heat, if not then this could be the grill element or the thermostat.
• When you turn the oven on, the household electrical supply trips on the Rcd (this is the earth trip in the fuse board sometimes called the breaker tripping) your fan oven element has gone to earth and needs replacing.

If this helped you why not get me a beer? Paul is from the Naturally he would appreciate beer How to Repair Home...

either its the oven sensor rod located at the top of the ovens cavity,or your bake element could be getting a hot spot which is when it gets a discolored spot in the element and can no longer pass sufficient current to heat the oven past 250 degrees

The heat from your vent should be a little lower than what the oven is set at. So I doubt if you have a problem but you might want to take some temperature measurements to see.

A small fuse is mounted in line with the power going into the control.


Service manual Page 22

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

next time send the brand name and model number so i can look up your machine,if it's a gas stove most likely it will be a bad ignitor,even if the ignitor glows it still could be bad,if the flame doesn't ignite and the ignitor is glowing change it out,if it isn't glowing pull out the ignitor and check it with a meter,common problem.

Check the door switch and the temperature probe. If they are ok, then the problem is likely in the control board. These boards can be rebuilt.