Sharp LC-26D6U 26 in. LCD Television Logo
Posted on Sep 30, 2008

Sharp Aquos LCD only shows analog

My Sharp LC 26DU had the sound problem I've seen posted here; it was repaired at an authorized shop (was told it was related to the insulation around the audio chip). When we hooked it back up to cable at home, it comes on saying 'analog', and we haven't been able to figure out how to make it change to digital. The original remote had died and we are using a universal that won't show the start up screen menus. Any ideas?

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

  • Contributor 2 Answers
  • Posted on Oct 13, 2008
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Joined: Oct 13, 2008
Answers
2
Questions
0
Helped
954
Points
2

You will prob. have to order a new original remote.  It has the options on it to change from analog to digital.  I don't believe there are any options in the menu or buttons on the tv that switch between the two.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Sharp Aquos LCD power on but no picture and no sound

Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
http://electronicshelponline.blogspot.com/
In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.
0helpful
1answer

Power light comes on along with OCP light. No screen or sound. internal switching noises coming from inside the tv

Sharp TV - Flashing OPC & Power Lights - YouTube

? 0:50
https://www.youtube.com/watch?v=BH1OcQ6dIEE
Jul 1, 2011 - Uploaded by Tweetssun
Sharp Aquos TV flashing a OPC & Power Lights in a pattern of 3 flashes, ... Sharp Aquos LC-32D44 - One blink lamp error - Nopicture or sound - Diagnosis ... Repairing Flat Screen TV - Blacked out with blinking red light ...Missing: 32dv22u

Sharp lcd tv power button flashing - HDTV - Streaming Video & TVs ...

www.tomsguide.com/forum/54708-4-sharp-power-button-flashing

Feb 8, 2012 - 7 posts - ‎3 authors
We have owned a Sharp 32" LCD TV for about two years. ... However a quick Bing search shows that the blinking green light usually means a bad power board, which seems ... No picture, no sound, just a black screen and two blinking green ... a cable surge block on the coax where it comes into the house. Sharp lcd tv power button flashing - Digital TV
19 posts
Oct 14, 2012
Sharp hd tv blinking power no picture - Digital TV
2 posts
Jan 7, 2012
More results from www.tomsguide.com
Missing: 32dv22u

Sharp Aquos LC 42DH77: Inverter, Backlight, Power and ...

www.normsweb.com/tektips/42dh77.shtml

0helpful
1answer

I need some information on buying a ac adapter or power cord for the Sharp Aquos Model LC-22SV2U.

Cord: http://www.newremotecontrol.com/catalog/dyn_accy_data.php?catnum=QACCD3097CEPA
Adapter: http://www.newremotecontrol.com/catalog/dyn_accy_data.php?catnum=UADP-0243CEPZ
On the adapter: I've seen them a LOT less expensive just recently. Google it and choose "shopping" to narrow results. There won't be many, but I think you'll find one at better price in just a few minutes. Try ebay as well; that's where I found repair parts for the same model. Good luck!
1helpful
1answer

Replacement screen for 45'' sharp aquos tv

The only vendor for this would be sharp or a authorized parts dealer. The cost of these LCD panels usually makes the repair senseless. You may get a cost estimate from sharp at 1800-besharp.
I hope this helps,
Skyassoc
0helpful
1answer

Analog to digital convertion

Yes,LCD tv have digital tuner inside.Just buy a digital antena.Plug it in the antena analog whole.Go to menu setup go down to ch.rescan should have all free air channels.
0helpful
1answer

No sound on analog

Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/
In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.
17helpful
2answers

LC-45GX6U

The DC/DC converter went out on your set. When you take the top off of your AVC box look for a 4" X 5" circuit board mounted on the front left corner. I have seen these fail causing you white screen. Order the part from your local Sharp service center. Part # RDENCA089WJZZ
0helpful
2answers

Sharp Aquos LC C3242U - Intermittant Sound Switching from Mono to Stereo

Not sure if I just got lucky or if the problem is solved..I hooked up my Sharp Aquos LC-32D64U the other night and I had the blue audio box pop up. Mine was only in Mono and would not switch to Stereo...Well, Local cable company is of of Hi-Def boxes but I thought what if my Digital box is bad/old or has some sort of problem. I went down to comcast cable company switched to a different digitial box..came home, hooked it up and so far no blue audio box, plus now it shows that it's in stereo..good luck
Not finding what you are looking for?

706 views

Ask a Question

Usually answered in minutes!

Top Sharp Televison & Video Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Cindy Wells

Level 3 Expert

6688 Answers

matt martin
matt martin

Level 3 Expert

1259 Answers

Are you a Sharp Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...