Sony Triniton TV KV 32FS120 will not turn on

(V -stop) vertical section is faulty, bad soldering on vertical ic. or faulty vertical ic. also check for 13v-+ supply for vertical deflection...

Those blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices.
http://electro-medical.blogspot.com/
http://homenol.blogspot.com/
http://electronicshelponline.blogspot.com/
If blinks continue without any pause, the main board is faulty.
Search the site by type in the "brand name" to your device, in the "Search box at the top right of the display window of the Homepage" to get gathered related posts.

TV got internal problem and goes to standby due to protection circuit activation. In protection status, standby light would start blinking in sequence with 3 seconds pause. Let me know how many times standby light blinks to find out possible problem section in your Sony KV-32FS420 TV to suggest any solution.
Thanks.

I have a Sony SRS BBE Trinitron (WEGA). The last few days when I tried to turn it on using the remote the Red Light would go on but the TV did not turn on. I would have to press the power button again to turn it on.. I tought the remote battery was just low.

Today when I tried to turn it on nothing is happening and the Red Light is blinking 9 times ??? I tried to unplug it and try it again, still does the same thing ???

We need help...
Lori Nall

Hi Simonbra,
According to the service manual. the 5 blinks is due to a defective IC on the M board, The defective part is IC001
I can send you the service manual if need be.

i have a unvirasal remote how do iget the codes for it

The model number is KV-36FV15 and blinking is constant no pause

can you recheck the model please

This is usually an indication of a failure in the scan amplifier sections. When the scan amplifiers or high voltage sections fail, the main power supply will usually also require servicing.

It is very common that the fly-back and high voltage multiplier and also the horizontal output stage fails in these sets. Along with it, the power supply will usually require to be serviced. On rare occasions, the vertical deflection amp fails.

Jerry G.

I have a
Sony KV-27S42 and its blinking 4x then pause and 4x again. help please!