Kenwood kdw243a have a new kenwood kdw243a and when i turn it on it displays e4.  Any ideas what this means.

It means your leak detector has detected a leak.

Hi,


The error code E4 means selector switch pads is stuck.
First try a hard reset. Unplug the unit for 10 minutes and then switch on the dishwasher. Most cases you won't get the error message.
If you still get the error message then you need to take to service center to get it repaired. Mostly, the inner connectivity between the pad and circuit board is loose/bad.

Hope this helps.

Shane

Hello,

Some models of Frigidaire washers come with a digital readout display that informs the operator of the unit's function and any errors.

Error codes indicate that a problem has occurred and should be addressed. Different models of Frigidaire washers may vary in their fault displays.

Some washer models use flashing lights at the unit's start, door lock, wash, rinse, final spin and control indicators to display error codes.

Hope this help?

Thanks.

E3 means the base is full of water. A quick fix is to tilt the machine back for 10 mins or so but you need to find the cause of the leak and repair it

error code E1 refers to "lack of water inlet pressure" the valve the elctrically lets in the water might be at fault

Hi kssami9,

I'm Harvey the Master Plumber.

Your problem is: Your dish washer kenwood model kdw243a is not working and displaying the error code E3 please give you the solution.

First try to reset the d/w. Just turn it off at the circuit breaker for ten minutes.

Feel free contact me again!
Please give me a rating here at fixya.com before you sign off
Thank you,
Harvey your Master Plumber

did you find out what was causing this because mine is doing the same

Error code E4......I have the definitive answer.
All the recommendations to tilt the machine are totally wrong!!!!! It may work in the short term but is a bodge-fix and covers up the "real" problem - you have a water leak- its as plain as that.
There is nothing wrong with the Kenwood and it has a 'Flood Sensor' that is filling with your leaked water.
I too was suckered into this quick fix but it didnt work for me; then I spoke to a neighbour who is also a dishwaher repair man.
We removed the machine , removed both side-panels (yes its easy for a DIY), dried out the water from the bottom pan (the sensor sits in a small recess right in the middle of the bottom pan). The machine was switched on and we checked for a leak; now there are many pipes and you need to observe just where the leak is. In my case the water was pouring from a broken pipe, but worse still it was leaking right onto the mains electricity !!!!!!!
So DONT mess with bodge fixes - they may kill you!!!

kdw243a code E3 what doesthis mean. ??? pleae.. adres Poland,,,,,, e_mail [email protected]