I have a motorola cp 110 walki talkie .red light comes on but no beep or commuunication

If you need one, you might have a look to some site where Motorola walkie talkies are being sold, like:.
Motorola Walkie Talkies and Two Way Radio

Motorola MR350R 35 Mile Range 22 Channel FRS GMRS Two Way Radio Pair

This one is really cheap:

Motorola Talker T40 2 Way Walkie Talkie Radio Black Red Pack
of 2

Or at Best Buy:


Two Way Radio 2 Way Radios Walkie Talkie Best Buy

You might try http://wirelesspro.com, we have found them to carry most TalkAbout accessories and batteries. Before ordering battery packs, you might try switching your existing good battery to the other radio and see if it solves the problem. This would assure you that it is indeed a battery problem.

roman-

contact motorola solutions
get support

mark
motorola support

Even the privacy codes are the same? Does the little light come on to tell you that it's receiving a signal?

Generally when a radio shuts off when you press the PTT button it is a sign of a bad or poorly charged battery. It takes more energy to transmit than to receive. The fact you have a charge which the light does not come on indicates you have a bad charger or bad connection between the radio and/or battery and the charger. Clean your battery contacts (on both radio and charger) with a pencil eraser and see if it clears up the problem. If not, you have either a battery or charger problem.

Best regards.

Here's a link to the user guide http://www.walkytalky.com/Manuals/CP110%20display%20user%20guide%206880309T07b.pdf

Best regards.

motorola need service contacts are holding in it.

Most Motorola radios give a beep-beep when the batteries are low and need changing. Make sure to use a good brand of battery. One other thing to check for is leaking batteries, the crud with cut down on performance.

• may be the walkie talkie can recieve signals only to an certain distance,so it may be due to the signal problem........
• if the reciever is beyond the permitted distance it loose its frequency...........
• or else the person who is calling walkie talkie might not hav signal in that area.....
• and if the walkie talkie does not recieve any signal then the receiver component present inside the walkie talkie might be damaged.........
• and if it does not reply to an signal transmitter might be damaged..........
• i hope my answer would be sufficient for u.....thank u......

Someone already asked this question here:
http://www.outdoorsmagic.com/forum/forummessages/mps/utn/5766/v/8/cp/1/
Hope that helps!