Can't write to my msa1000 luns

Hi, a similar issue with MSA 1xxx series StorageBoxes is found in the HP - Enterprise forums 409 Storage Box 1 Power Supply Failed MSA500 G2 . The error code might not be the same but if the device is still able to boot and run, you can clear the error code by pressing the left & right simultaneously while the error message is in display. This is stated in the following picture shown below:


Alternatively, you can check the MSA 1000 error codes in the user manuals shown below:
http://community.hpe.com/hpeb/attachments/hpeb/bsc-257/382/1/66469.pdf http://h20566.www2.hpe.com/hpsc/doc/public/display?sp4ts.oid=415598&docLocale=en_US&docId=emr_na-c00607272

teri maa di lun saleya lun farr k chuppa la fudi deya lun farr sala...........

1. RDP (mstsc ->IP address) to SVP of this storage (you can also connect via serial cable to storage)
2. Make sure SVP is in modify mode
3. Go to Install -> Change Configuration -> LUN Confirguration
4. Go to particular port on which your Host Group is reside.
5. Check LUN status: If it's other than "Normal" then you have to generate password to unreserve LUN. (password you will get from HDS support.
6. Once you have password right click LUN & do force reset. Enter Password & it's Done :) LUN status will come back to Normal & you will be able to release the LU path.

https://h30434.www3.hp.com/



ask HP, we are not HP, at all.

short answer map the drive.
google how to map drives.

Update the HBA drivers and Firmware. it may cause he problem

The SCSI terminator may be disconnected.
If no physical terminiator, then one of the devices has the terminiation set.

Also, check the LUN (logical Unit Number) make sure each SCSI device has a unique LUN. The LUN can be set on the back via the "push button"...

0xC0000005 0016A9D8

First off all,i do really like the concept of your website.It's a real good gimmick!
I had to replace the whole controller (which was defective) to get msa 1000 working.

Regards

Can you go to the server and right click on my computer, then select disk management, then see if the physical drive shows up there. This may be as simple as a drive already having a drive letter assigned to it.

Hi, Logical Unit Number(LUN) can be configured VIA web based inbuilt software on Hitachi. and for device configuration you can use either hitachi HDLM or Opstore to Monitor. Detail you problem so that I can brief you lot. By that time you can check www.hds.com/pdf/9500V_architecture_guide_415_02.pdf Thanks Arun