Question about Tappan 30IN ELEC IGNa Oven

1 Answer

Where is the ignitor

The location

Posted by shirley alameda on


1 Answer

Gene Meier

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 2,341 Answers

Hello Shirley,
The ignitor is located on the main bake access it ya would need to remove the floor from the oven which is typically held in place by a couple over sized screws,remove those screws and lift off the oven floor and the ignitor will be their.


Posted on Nov 06, 2011


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the ignitor to the estate oven located

It will be located at the back of the burner manafold.

Nov 23, 2017 | Ovens

2 Answers

Westinghouse oven GOR474WLP won't light


Nov 19, 2011 | Ovens

1 Answer

Oven is not heating up. Gas burners on stove work.

your unit may have a bad ignitor .. this is located in the bottom of unit most uits the inside of oven on bottom will have a metal plate that cna be removed by taking 2 screws out of the rear part of the metal panel... raise it up and you will see a ignitor under a heat shield that can be should glow bright when unit is turned on and should have 120 volts coming to it...

Feb 03, 2011 | Ovens

1 Answer

Hello when i put my temp for my gas stove on say 350, the pilot is glowing but it doesnt seem to flame/heat up, and i get a somewhat odor of gas, could the therometer need replacing or maybe the ignition...

Your glowbar ignitor part must be replaced, Unplug the range and turn off the gas. Remove yje oven racks, The oven base pan. Then remove the flame spreader. You will see the glowbar ignitor attached to the side of the bake burner. Remove it and replace it with a new ignitor. Replace all the range parts.Turn on the power and turn on the gas supply.

Copy and paste this site for the location of the ignitor you can also purchase the part from them.

Jan 01, 2010 | Frigidaire FGB24T3A Gas Single Oven

1 Answer

My kenmore oven needs a new ignioven tor. How do i remove the old one? Model No. 9117147810

Hello SHpall,

To get at the ignitor, you need to remove the shroud around it and that will allow you to get at the screws that hold it in place, etc.

First, make sure the power is turned off to your wall oven, at the breaker panel. Then you can remove the racks and get to the ignitor shroud at the back of the oven. Once you've got the shroud (cover) removed, you should be able to remove the screws that hold the ignitor in place and then carefully pull it and the wires out, so you can disconnect them from the oven's wiring harness.

Some models do not have connections at the back of the ignitor and you will have to remove the oven to gain access to it from the backside.
The bes thing to do is first check from the inside, as that's obviously the easiest to do without having to take the oven out of the installation location.

Reinstall the new replacement ignitor and reverse the above steps and you should be fine.

I hope you find this Very Helpful and best regards!

Dec 24, 2009 | Kenmore Ovens

1 Answer

Where is the oven ignitor located?

it is under neath the bottom plate of the oven cavity.usually there r 2 screws at the back of the bottom plate.once u remove them,u will be able to lift up the plate and then u will have access to the ignitor.

Aug 17, 2009 | Ovens

1 Answer

I need to change my oven ignitor and I need a diagram to show where it is located. I have a Frigidaire model FGF353BADB. Free standing gas stove/oven.

Here's a diagram of the oven along with the Oven Ignitor (Part #19 on the diagram) and the Broiler Ignitor, (Part #26 on the diagram). They are located behind the gas deflectors located at the top and bottom inside the oven compartment, accessible from inside the oven, but you'll need to remove the rear panel at the outside back of the stove to disconnect the terminals tha supply voltage to the ignitors.

Be sure to turn the breaker off and/or unplug the range from the 220V-AC outlet first.

Hope this helps you complete your repair. Best Regards!

Jul 31, 2009 | Frigidaire FGB24S5A Gas Single Oven

1 Answer

Ignitor not working

Check the ignitor, Make sure that the connection are good and tight. If they are then look at your control board which is located behind your clock. Then check your relay also.

Feb 20, 2009 | Jenn-Air JGW8130A Electric Single Oven

1 Answer

Frigidaire model number FGF356MXAWR, Serial #VF34511587 oven

it is probably the bake ignitor needs replaced. the only way to check it is with an amp meter. however, this is a part that does fail alot, and you can buy one for pretty cheap. it is located mounted on the bake burner by 2 screws. and it only involves splicing 2 wires, (the wire nuts you need should come with the new ignitor)

Jan 04, 2009 | Frigidaire FEB27S5A Electric Single Oven

1 Answer

Viking wall oven No ignition

There is a transformer located on the oven that generates voltage to the ignititors. You have a bad transformer or a bad connection.

Dec 21, 2007 | Viking VGS0166 Stainless Steel Gas Single...

Not finding what you are looking for?
Tappan 30IN ELEC IGNa Oven Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Tappan Ovens Experts


Level 3 Expert

85239 Answers

john h

Level 3 Expert

23515 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

35783 Answers

Are you a Tappan Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides