Have a new ULTRonic Global clock. Came in a box, well packed but apparently no setup instructions. Have been able to set the clock after much guess work. Temperature, Humidity and trend seem to work. Unable to get day of the week set and Forecast doesn't work. Where can I get the setup instructions? Thanks

Atomic clocks have antennas that are directional and reception may be improved by turning the antenna to increase signal strength. Place the radio controlled clock along a wall or near a window that faces towards Fort Collins. Locate atomic wall clocks at least 4-8 feet away from computer monitors.

Atomic Clock Synchronization (weathershack.com)

Select "change time zone" and press to remove the "automatically adjust clock for daylight saving time" symbol to automatically update the clock when daylight saving time is applied.

www.citizenwatch.com/en-ca/support/setting-instructions/

heres an answer another question had that might assist u in some way:
Hi,

According to the instructions that we received with our clock. You should be able to get the Instruction manual from [email protected]. It is also supposed to be under the support section of the website www.dpi-global.com but I couldn't find such a link.

However the "Operational Support" insert has the following:

Setting the clock
1. With the unit powered off, press and hold the "Clock/Display/Play/Pause Button" for at least 4 seconds.
2. While holding the "Clock/Display/Play/Pause Button", press the "Hour" and "Minute Buttons" to adjust the hour and minute on the time.
3. When the correct time is selected, release the "Clock/Display/Play/Pause Button" to set the clock

Setting the Alarms
1. With the unit powered off, press and hold the "AL1" or "AL2" Button for at least 4 seconds.
NOTE: An alarm icon will begin to flash on the LCD display.

2. While holding the "AL1" or "AL2" Button, press the "Hour" and "Minute Buttons" to adjust the hour and minute on the alarm time.

3. When the correct time is selected, release the "AL1" or "AL2" Button to set the clock.

4. Press the "AL1" or "AL2" Button consecutively to switch alarm one and alarm two between sounding to a buzzer, the currently set radio station, or a docked iPod.

Need help to set week day and 12 hour day instead of 24 hour day on Ultronic weather clock sent to me without any instructions, can you help or tell me who to contact to find out how to set up this clock?

Set up a pay pal account or just use your credit card then buy on-line
http://global.rakuten.com/en/store/trendone/item/10029501/

If not found with the model and Google try to find the website for the maker.

This clock keeps track of the temperatures for each of the last 12 hours. So on the bottom, you'll see the temp at 12 hours ago (-12), 6 hours ago (-6), etc. On the left side, you'll see the temperature in Farenheit go from +5.4 to -5.4 from where it is currently. So if the temperature is 70F degrees right now, and it was 65F degrees 12 hours ago, then it'll show -5 in the first -12 column. It will always be at 0 for the current hour on the right. The scale on the right is in Celcius so it does the exact same thing as Farenheit.

I would contact Disney at the following link:

http://aimg.disneystore.com/content/global/guest_services10/contact.html

My good guess would be that it will be cheaper to replace the entire clock but I would contact Disney. Good luck.

to set the time: switch to timedisplay and hold the "S" key for three seconds, then adjust with the arrow key´s
to set the date: same prcedure as time but first switch to the date display