Frigidaire Dble OVen Model FEB30T6DCC Stainless (electric
Is there a way to remove the door so that I can clean the glass between? Dirty water spilled into the vents on top and of course, it shows up as a lovely dirty stream down the front on the inside. The manual only says DONT SPILL here, okay my bad. I was wiping the inside down and I spilled. I thought I could remove the front by the 3 phillips screws at the top, seemed plausible, but it doesn't budge. This stream is driving me nuts! Can you help? I called 800 number, got a foreigner, who told me I was not supposed to spill anything in the vent. Got that part, but like I said I did. They offered no resolution. There has to be a way.. Andi
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Good Morning Suzi - Generally,
qualified technicians often perform complicated part replacement such as this,
however this may or may not be specifically for your model. Below are generic instructions
that I found on how to take your oven door apart to remove any stains that may
be caught down in the door vents.
needed: Phillips head screwdriver or small quad bit driver.
A. Open Door remove 2 screws and washers on door lining at door hinge area.
B. Refer to owners guide with door in broil stop position lift door assembly
C. Lay door on table, position so that handle hangs freely over edge of table
D. Remove 2 screws and washers that secure handle to lining assembly.
E. Remove 8 screws that attach textured steel door wrapper trim to lining
assembly 3 at top, 3 at bottom, 1 on each side
F. Lift door lining up and out of wrapper trim assembly.
G. Lay lining assembly on table with wool shield/inner part of lining facing
H. Remove 2 glass clamps via 2 screws per clamp. These clamps attach innermost
clear glass to wool shield.
I. Lift out center clear glass from wool shield, this glass just lays onto the
wool shield and is held in place by the glass/ clamps in item H.
J. Clean each glass with appropriate cleaner, Windex, bon ami, fantastic, etc
K. One glass that remains in door lining assembly can at this time be cleaned
without further disassembly the lining assembly.
Basically, oven hinges more or less work on the same principle. However, they do not normally pop out so I am reluctant to say what the problem is. Normally your handbook will tell you how to remove and replace the oven door.
If you haven't a handbook, try the manufacturer or repost under the Frigidaire section.
The door must be taken apart at least most of the way to clean glass. Just so you know, this is a problem with a LOT of the newer makes and models. If there are 2 screws behind the handle, take them out and some of them come apart enough to get your hand a paper towel in to clean. Otherwise, the door must be removed and completly diss-assembled.
in your manual the is a section about how to remove the oven door. after removing the outer panel is removed by a few phillips screws around perimeter, of panel perhaps 2 for handle need to be removed depending on model. not a terribly difficult task, but take time and youll be fine
We Use DeBruce Polish on all our cooktops. DeBruce also works on
stainless steel and polished granite, marble, porcelain, formica and
glass.DeBruce is non-toxic odor-less and eco-friendly. You can get
DeBruce on line at debrucepolish.com.
To dismantle the kitchenaid pro line oven door: there is a lever over the hinges that attach a door to the oven. The lever is right on top of the hinge. Pull the lever up. When that lever is in the up position, you can pull the door out.
Try to remove the door. For the Kitchenaid, thereis a hinge on each side with a latch that flips up. Once the door is removed, remove all screws and you should be able to get at glass. Be very careful, the Kitchenaid had four panes of glass.