How can I reset time zone and alarm on westclox 70026

Scrape the corrosion from the device battery terminals with a small screwdriver. Needs to be bare metal contact.

Take the battery out for a while, then reinsert it. If it does not correct itself in 24 hours, you may have a faulty unit. Try contacting Westclox with your modle number after that. They're not that expensice, so just get another one, and save your receipts for at least the manufactures warranty time frame. (Usually 90 days)

Manual on the link below.
If you would like to see the instructions, they are in .jpg format:

Front page of instructions:
http://www.poyntsource.com/New/Pathimages/westclox%2070026%20-%20page%201.jpg

Back page of instructions:
http://www.poyntsource.com/New/Pathimages/westclox%2070026%20-%20page%202.jpg

You might want to save these images on your computer in case the webpage is no longer available.

Greetings.

According to the product manual, press the 'ALARM ON/OFF' button on the back of the clock until the bell symbol and 'Zz' disappear from the display screen. These symbols are between the hour and minute digiits, above the colon ( : ).

If you would like to see the instructions, they are in .jpg format:

Front page of instructions:
http://www.poyntsource.com/New/Pathimages/westclox%2070026%20-%20page%201.jpg

Back page of instructions:
http://www.poyntsource.com/New/Pathimages/westclox%2070026%20-%20page%202.jpg

You might want to save these images on your computer in case the webpage is no longer available.

Good luck from Detroit, MI.

It's most likely because of Daylight Saving Time. Your clock receives a signal through the air once a day from the actual atomic clock, much like a cell phone receives the time from your cell phone service provider, and it automatically resets itself to the exact time each time it receives this signal. Remember that the middle of the year (the second Sunday in March until the first Sunday in November in the US) is Daylight Saving Time for much of the United States. The clock has an option that allows you to set whether you are observing Daylight Saving Time or not. If this is set to "off", the time will be one hour behind until Daylight Saving Time ends (November 7th). Make sure this is set properly, and your problem will be solved.

I found the manuel, it's go down on this page http://www.poyntsource.com/New/WWVB_Video_Clock.htm