I need a new handle locking clip for my quinny speedi sx

Hi

You can order from your local Quinny retailer or direct from the customer care team on 01284 413 141 Mon-Thur 8.30-6.30 / Fri 8.30-4.30 (Excluding Bank Holidays)

RRP for Quinny Speedi front wheel unit is 27GBP
RRP for Quinny Speedi rear wheel (each) is 37GBP

There would be a p+p charge of 3.99GBP or 8GBP on an order placed direct depending on the weight of the final order.

Hi

Please e-mail to the customer care team for assistance in purchasing a replacement seat

[email protected]

Hi

We do not recommend that a customer attempts to disassemble the handlebar. For repairs of this nature the chassis should be sent to the Quinny engineers.

Visit www.quinny.com and select the country you're in, then choose the "Contact Us" tab for your enquiry to be sent to the customer care team in your country.

Good Afternoon

Apologies we are not sure what product you need. Please contact [email protected] with a photograph to demonstrate which part you require.

Hi you can buy a replacement 1 on ebay

The quinny speedi should come with the adaptors to fit the bassinet (the quinny dreami) Once you remove the pushchair seat unit by undoing the clips and undoing the velcro the fastenings you then need to remove the 2covers or bumper bar(depends on model) above the quinny logo on the pushchair frame. You do this by pressing the silver buttons to release them and then they should slide off. You then replace these with the adaptors for the carrycot. These slide into position until you hear a click. The carrycot is then place onto these(again it will click on) parent facing. To remove the carrycot you then press on the silver buttons on the carrycot unit and lift off using the handle in the carrycot hood. HTH

f the dreami carrycot or the maxi cosi car seat are attached, these will have to be removed first. Apply parking brake Release the handle bars by unclasping the silver clips on the frame. Push down handlebar to lowest height as you press in the silver button under the quinny logo on the very top of the handlebar( in the middle of the foam padding) with a downward thrusting motion. The chassis should then collapse for storing. To unfold then release the transport clip on the left hand side with the red sticker on it and unfold upwards adjust handlebar to required height and lock by closing the silver clasps either side of the frame. If you want me to do a pic/video demo let me know. HTH

Hi,

If you go to this link, you will be able to contact the suppliers to order the adapters:
http://www.quinny.com/quinny/forms/contactFormV3.aspx?mode=contact&language=gb-en

I hope this helps.

you can get replacement seats & hoods from quinny.com they are really helpful, seat is £65.00 Hood £35.00 hope this helps

In the middle of the underneath of the pushing handle, below where the hand brake lever is there should be a button. If there is, this is what you do.
1) put the foot brake on so the rear wheels wont turn.
2) unclip the clips on the frame that allow you to adjust the height of the pushing handle, they open up, and leave them open, like this the handle you push the buggy with should slide up and down.
3) pull this handle out to its tallest position
4) Hold the handle and press the button mentioned at the start in and hold it in
5) Then quite quickly push the handle down as though you were either pushing it to lower its pushing height, or shoving it away in a temper. It needs to be a firm and quick movement.

Ta da!! After a couple of tries it should click and fold up.

I hope this helps.