DD24DCB6 top drow not working no power - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Consistent with the AIR PUMP warning code you saw, I am 75% certain that you have at least one clogged catalytic converter. If not a catalytic converter, some other exhaust system obstruction.

It is only necessary to post your question ONCE.

When this happens to me I just keep trying, and after 4 or 5 times it works.

same problem but no solution. Maybe the dump!!

I have the same fridge. It was driving me crazy. I emptied it. Cleaned it. Defrosted it. And was ready to dump it. Then worked it out. As it beeps when the door is open. How does it know. Because when the door is open the light is on. I taped up the light nob with masking tape, on top left of fridge. No light now
But no beep Yay!!!!

The fuse is going to be in your fuse box. On the diagram it should show either cigarette lighter or accessories. It is there you will find the fuse.

theres a shortage in the circuit try check the rectifier diodes at primary power supply section, not dangerous to little knowledge,refer to a qualified service technician

the amplifier is drowing too much current, and components are getting heat from that
check your amplifier final stage tempreature,
all so check a short of the circuit.

firstly check your sleeping timer set ups. if that is okey, then check the following
the power supply components eg
power transistor on the power supply lekage
zener diodes, power diodes of the bridge rectifier.
in short the supply is drowing to much current, hence semiconductors are heating up and reach a cutoff point, and saturates

Hi i want equivalent code in c#

dvColumns = New DataView(schemaColumnsTable)
dvColumns.Sort = "ORDINAL_POSITION"
DT.Columns.Add("COLUMN_NAME")
DT.Columns.Add("DATA_TYPE")
DT.Columns.Add("Length")
For i = 0 To schemaColumnsTable.Rows.Count - 1
drow = DT.NewRow
drow("COLUMN_NAME") = dvColumns.Item(i)("COLUMN_NAME")
If CType(dvColumns.Item(i)("COLUMN_NAME"), String) = "Quantity" Or CType(dvColumns.Item(i)("COLUMN_NAME"), String) = "Cost" Then
drow("DATA_TYPE") = "Float"
Else
drow("DATA_TYPE") = "Varchar"
End If
' drow("DATA_TYPE") = "Varchar"
drow("Length") = "255"
DT.Rows.Add(drow)
Next