Wires got cut from factory harness to the factory stereo need to figure out wire color codes

read (you meant main harness to radio sub harness.)
and car may have 5 or more harness for 5 or more very complex radio head end options new,so only the real service manual covers all that for sure,or if lucky 2nd fiddle here.

https://eautorepair.net/Marketing/Default.asp

Hi, you can usually buy a stereo wiring harness that plugs right into your car and they are color coded to match the standard aftermarket wire radio harness, all you do is take the plug from your new stereo and match the wires with the adapter, just connect the matching wire colors. it's super easy and well worth the $15-20, and you don't have to cut up your factory harness.
good luck!

Go to your local auto store and get the Hanes auto manual for this care and they should have a wiring schematic for you to follow also you can look your new stereo up on the web and find out what each colored wire goes to what!!! Good luck

The stereo side of the wires should be labeled. Check out the12volt.com for a wiring schematic for the truck side. I advise against cutting and splicing wires for a stereo installation though. They make inexpensive harness adapters that will allow you to splice into the stereo harness without cutting into the factory wiring.

Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.

ok that problem is where u cut the wires on the rdaio harness u cut is a dimmer wire for your lights on the radio need to figure out which if u have a autozone or advanced parts store they have a radio wire harnes kit has all color code and wire color tells what goes where and what the wire is for

Get yourself an adapter harness. they are less than $20 and you will save yourself the biggest headache trying to figure out the wiring

the easiest way to install a new radio is to get the wiring harness adapter for your vehicle it runs about $25 and then you do not have to cut the factory harness. the wiring codes will come with the new harness and is just matching up there color code to the new stereos color code.

Radio Constant 12V+ Wire: White/Green
Radio Switched 12V+ Wire: White/Red
Radio Ground Wire: Black
Radio Illumination Wire: n/a
Radio Dimmer Wire: Red/Black
Radio Antenna Trigger Wire: n/a
Radio Antenna Location: Rear Glass
Front Speakers Size and Location: 6 1/2′ Doors
Left Front Speaker Wire (+): Blue/Green
Left Front Speaker Wire (-): Gray/Black
Right Front Speaker Wire (+): Red/Green
Right Front Speaker Wire (-): Brown/Black
Rear Speakers Size and Location: 6′ x 9′ Rear Deck
Left Rear Speaker Wire (+): Blue/Yellow
Left Rear Speaker Wire (-): Gray/White
Right Rear Speaker Wire (+): Red/Yellow

you should never cut the wires on your factory harness... metra and other companys have harnesses that fit your car and would provide you with a correct wire color code you need to hook up a aftermarket stereo keep that in mind but i will post the wire diagram u are looking for