I have a frigidaire gallery stove.I need a temperature sensor . Model No. PFEF385JFT3.Serial No.NF82105720.Where can I get one.How much is it?I believe this stove was puchased in Canada.

Hello, Joan -

Clarification: You are asking about a Frigidaire Gallery model gas stove and how to use the self-cleaning feature for the oven? If so . . .

You will find the instructions here:
https://www.hunker.com/12002208/instructions-for-a-frigidaire-gallery-series-self-cleaning-oven

If you need the user manual for your oven, you can add the model number by choosing Comment and adding the information there, so I or someone else volunteering to answer on Fixya.com can look for and provide the right link for a download of a free manual.

Note: There is more than one Frigidaire Gallery range model numbers made:
https://www.frigidaire.com/Kitchen-Appliances/Ranges/View-All/?filter=Feature02012:Feature02012

Best wishes.

It has a bad temperature sensor

If you need further help, reach me via phone at https://www.6ya.com/expert/steven_a67ead41eb5fc62a

Good Afternoon Friend, this is Z. Thank you for your post!

I understand you are seeking the fuses location in your Frigidaire range. May I please have your model number? You can typically locate the serial tag (which lists your model number) in the storage drawer, on the right side. Please describe what your appliance is doing so that I can assist you better in pinpointing the problem before you take this step. Thanks!

Hello arab125 - I understand that the timer and clock works fine, however from what you have described it sounds like the range could possibly have a wiring failure, faulty sensor, or an issue with the EOC. I would suggest contacting a professional to move forward accurately.

The Electronic control has lights inside for the time and for the temperature. Over time the lights get dim (Frigidaires do it a lot). The Electronic control is not a Servicable part. You must buy a new Electronic control.

Press clock button, then press temperature up button. Time will begin to change. When you have the correct time set, press the clock button again to save.

The problem is the oven temperature sensor, this is located inside the oven near the top. For diagrams and illustrations of your specific model go to www.appliancehelponline.com and enter your model #

Oven temperature sensor is open (above 3000 ohms)
Check resistance of oven temperature sensor, check for open wiring between oven temperature sensor and control

The top element normally operates only when you turn the temperature control all the up to the broil setting as it is the broiling element. If it doesn't work at the broil setting, suspect a bad brioler element or a faulty temperature control.

The identification label from a Frigidaire Gallery Commercial Heavy Duty Moisture Sensor drier has come off. I need to download operating/user manual. How can I get the serial no. or model no. The drier is 4 years old.

F10 is a Runaway temperature issue.
There are three possible scenarios:
1. The temperature sensor has failed.
2. The electronic control has failed
OR
3. The connector between the temperature sensor and the electronic control has failed.

The connector can be troublesome. The first thing to do is eliminate this potential issue.

• Remove the back panel.
• Locate the temperature sensor plug
  
• Cut the plug off the temperature sensor wires and the corresponding electronic control wires
  
• Using ceramic wire nuts, secure each temperature sensor wire to the corresponding electronic control wire.
  

If you need further assistance, let me know

Regards;

reg501

The FixYa Team.....