I lost the plate that connects the camera to the tripod. Where can I get a replacement? I live in Boulder, Colorado. Lynn

Take your tripod to a Giotto dealer, or go to www.giottos.com/ and order a replacement quick-mount camera plate. While you're at it, buy a spare!

That model is not listed here: http://www.tripodquickrelease.com/Sony_Quick_Releases.htm
but check the sizes to see if it might fit.

Try this site http://www.tripodquickrelease.com/Sunpak_Quick_Releases.htm

Tripod Model: 2001UT Quick Release: SP620-731

If it's a quick release tripod you need to remove the quick release plate (Usually a release lever to the side of the top of the tripod) and then fasten the plate securely to the camera and then the plate to the tripod. Older non-quick-release tripods have a knurled screw located below the flat area where the camera is attached. If the screw is missing, get a relacement from your local hardware store - 1/4" -20. (Find a way to keep the new one from getting lost.)

Try www.TripodQuickRelease.com for that part. There is listed the widest selection of quick releases and support more brands than any other web site I’ve seen.

The part you are looking for is the Vanguard QS-10.

Get it via mail order here:
http://shop.thefotogeeks.com/vanguardvt-840quickreleaseplate.aspx

or ebay:
http://cgi.ebay.com/Vanguard-QS-10-Quick-Release-Plates-/170479531839e

Quick release plates can be purchased on amazon, here: Amazon com Dynex tripod quick release plate. Take a look. Wish you ebst of luck.
Thomas

I also have the same problem. I lost the plate fo my kalmar camera tripod? Did you find the source of it?

I found a source for replacement parts at http://www.sunpak.com/service.html

(My monopod lost its ruber foot)

i lost the same part and i don't know what to do :(