Kenmore HE2 front load washer. All power to the maching is good. Thhe start button just beeps in quick sucsession. Won't start. It seems to think the door isnt' closed but it is, and tightly. (have a new seal about a year ago). Thanks.

https://www.shopyourway.com/questions/1038313
https://www.shopyourway.com/questions/1211982
https://dengarden.com/appliances/whirlpool-front-load-washer-problems
https://removeandreplace.com/2014/12/06/how-to-repair-a-dishwasher-leaking-water/

Even a blonde can do it! Quick fix/repair for Kenmore He2 ...

? 4:57
https://www.youtube.com/watch?v=4o9hWHQkOMM
Sep 1, 2013 - Uploaded by And Justice For All
Quick fix/repair for Kenmore He2 front loading washing machine... a Kenmore He2 front loading washing machine when blinkinglights error code occurs ... How to Clean Front Load WasherDrain Filter and Empty the Water ...

Front Load Washer Pump Clean Out - YouTube

? 3:03
https://www.youtube.com/watch?v=f9uS8_0-pWY
Sep 6, 2012 - Uploaded by GE Appliances
If you have a front load washer with a pump filter, your pump filter may become ... pressed start again but it still stops and the cleanpump light still comes back on. .... Samsung Washing Machine cleaning the pump & coin trap

Either one of your water valves isn't working properly, or the lines have sediment restricting the volume of water . What I would do is turn the water to the machine off and remove the water lines and make sure they aren't filled will calcium, etc. and look in the water valves where the hoses connect because that are, which has a screen, may be full of nastiness. If both those are good then the water valve solenoid(s) are stuck and won't open. The humming sound you hear lets you know the rest of the machine is working because the sound is generated by power being applied to the valve by the control.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

Your door switch is not working, the machine thinks that the door is still open.

hello, have you checked the fuse inside the washer it will be located the washer's circuit board but beware if it blows again then you have a dead short good luck
regardsshaun

Check the drain filter and the drain hose at the back.

Drain filter access is located in the fro lower section of the front size. You need to remove the trim at the base of the washer and to undo the cap, turning it counter clockwise. Disconnect power before starting and keep a container ready to collect the water.

Unplug your unit and take the panel back off and check to see if any wiring came unplugged.

1 Beep/E10--Error: Water doesn't enter Cause: Water supply problem, Check kinks and faucets
1 Beep/E10--Error: Water leaks Cause: Water connections loose,household drain clog,oversudsing. Correct problems.
1 Beep/E10--Error: Dispenser drawer is open Cause: Washer will not operate if drawer is open.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

Unplug machine, push reset button locate in the owners manuel