Ignition key won't release to the lock position

Hi Aldene, Your vehicle seems too young to have a problem with a worn key so I suggest that the problem was related to the position of the steering wheel and the tongue of the locking mechanism. Sometimes when the lock engages it is under the load of the weight of the front wheels, if they are not in the straight ahead position. A small movement of the steering wheel is usually enough to release the steering lock. Regards John

If the ignition normally only locks with the vehicle in park position, then check the switch on the gear lever mechanism is working.
If not, then you'll have to jiggle and wiggle that key out or replace the ignition lock.

Gear shift is not totally in the park position - had the same problem with a 2011 Acura TL - a rubber band kept the gear shift lever from totally seating in the park position.

The steering wheel was turned when the key was removed. So when you try to turn on the key, turn the wheel one way and the other way to release the pressure on the key. The key should turn ok.
Hope this helps.

Most newer models have a safety feature called
shift interlock. This prevents the key from being turned back
to the lock position if you forget to place the gear selector in park.
Depending on the model,
If it uses a cable, it may be sticking or needs adjusting.
If it uses an electrical solenoid. may be blown fuse or park switch.
Tap, shake, and pull up on the shifter and make sure it's in park.

make sure the stick is in reverse and the key is all the way in the ignition

Ignition - Key Stuck In Ignition Switch/Won't Turn Bulletin No.: 06-02-35-005 Date: February 28, 2006 TECHNICAL Subject: Key Stuck in Ignition, Key Will Not Return to Off Position, Shifter Button Won't Release in Park Position (Adjust Shifter Detent Finger) Models: 2002-2005 Chevrolet Monte Carlo Condition Customers may comment on any of the following conditions: - The key is stuck in the ignition cylinder. - They cannot return the key to the off position to remove the key. - The shifter button won't release in the park position. Cause This condition may be caused by the detent finger shifting over time. This may result in mis-alignment and binding of the shift rod on the shift position guide.
WHERE YOUR SHIFTER IS YOU WILL HAVE TO TAKE IT APART ..MAYBE THE RUBBER BOOT IS IT THE WAY,OR THE SHIFT LOCK SELINOID WHENT BAD

stick the key in the ignition, turn it to the on position, remove it within 5 seconds, then hold the unlock button down and press the lock button 3 times within 10 seconds and release both buttons. The doors should lock/unlock to give you confirmation and your key should work.

Hi nicoleelgert, i suspect the steering lock is giving you the problem, all you need to do is turn the steering wheel left and right ( jiggle ) while turning the key in the ignition, it won't move much because it's locked but it will be enough to release the steering lock and allow you to turn key.. make sure you have the shifter in Park position too. Good luck . OK

try putting key in ignition on the on position release e brake put car in neutral