How much does it cause for me to buy this mixer?

Buy a new mixer.

When your mixer is not starting , you could have a motor that has overheated as the mixer motor is thermally protected. An electrical problems such as a reset GFCI outlet or electrical breaker may also be causing the problem.
The manual recommends turning off the mixer and also waiting for about 10 or 15 seconds, and turning it back on. If the mixer still will not run, wait for 30 minutes before trying again. The unit does not have a reset button, so if it still doesn't operate after a 30-minute wait, you'll have to look elsewhere for the problem.
1 (800) 541-6390 for customer service for counter top appliances and kitchen tools and kitchenware.

check and see that the blades are install properly that can cause your problem..if parts are worn out then you need to buy a new mixer.good luck.

Please clarify your question. I understand that you are thinking of buying replacement parts for the mixer to correct the gear problem. Is that correct?

The motor is probably burnt out. You will need to either replace the motor or buy a new mixer.

That's why I buy $15.00 hand-helds.

I know someone that somehow fitted a hand-held mixer onto their old mixing stand. It's wworth a try when you consider shopping.

Cuisinart hand mixers are not repairable. You can buy replacement accessories like beaters, but you can't buy any internal replacement parts.

I have a Cuisinart HM-70 and I stripped the plastic gears inside by trying to mix a really thick dough. It was easy to open and get to the plastic gears. When I called Cuisinart to try to get replacement gears, they said that they don't sell replacement parts and their hand mixers are not repairable. I looked all over the internet and no one sells internal parts.

Unless your mixer is still under warranty, I believe that you're out of luck and your mixer is headed to the electronics recycle pile.

Most handmixers today are sold with plastic gears - including high end brands like Viking. For me the lesson learned is to buy low end hand mixers (don't buy a top of the line 9 speed mixer) and treat them like they're disposable when they break.

your motor stator to the commutator is shorting between the copper bus bars and this welding of these bars together from heat constitutes a short circuit and its time to buy a new armature(expensive) or get a new unit and save the old parts

Just buy the replacement switch, buy a star or philips
screw driver and do it yourself. Just copy how it is mounted and get it done. Just e-mail to us the result.

Hi. Congratulations for researching mixers. I wish I had before I bought my Kitchenaid HD Pro. All mixer manufacturers over-rate their products. Goto www.consumeraffairs.com and do a search for each mixer you are considering. Most mixer failures are caused by mixing heavy cookie or bread doughs. Although manufacturers claim that their mixers can easily handle these doughs...They cannot! My Kitchenaid self-destructed after 30 batches of bread dough. "For the way it's made"! Indeed! I solved my problem by buying a Hobart N50 mixer. It's a 5qt. and handles anything I throw into the bowl. I bought mine used, and refurbished it myself. New these units cost $2,035.00 USD.

If this solution has assisted you, please rate it. Good luck! ricardok45.

The Kenmore 600 Watt Stand Mixer uses KitchenAid Accessories.