My picture looks like a bowtie. what are my options for repair?

I would look for dry joints and poor plug socket connections around the line output section.
Mind your fingers!!!!!

http://www.techghetto.com/tv-repair/

The tv have a problems known as a convergence problems,it dead.The tv colors lines R,G,B mis alignments,have colors shadow pictures or 3D pictures look alike?The tv convergence board have dead 2 STK convergence ICS and some or all of it resistors too.These parts on the tv convergence board,must be replaced to solved the tv pictures convergence problems.The shop,will cost u like $300-350 for parts and labors.

Ur tv have a problems,known as Convergence problems.This problems very common on all DLP tvs.Ur tv convergence board must have be replaced 2 STK convergence ICS,some or all it resistors.U know basic soldering,have tools,soldering iron,solders?Tries Websites like TvrepairWord.com,TvrepairKits.com to buy a covergence kit to repair it ur self.The shop will cost u $300-350 for parts and labors.

TURN YOUR COLOR OFF.IF YOU SEE THE RED,BLUE AND GREEN AROUND THE EDGES EX.SOMEONES FACE YOU CONVERGANTS IS OUT NEEDS RE LINEMENT.

you need a convergence repair kit. www.tvrepairworld.com has them which contain the CD with instructions, They also will have a remote for your model TV.

Ur convergence it dead.If can't auto adjust must replaced.Tries Tv repair World.com,Tv repair kits.

Did you go into the convergence menu and allign the colors? Here's the link where i fixed mine... it's got the remote control button layout to adjust everything.

Since you have the convergence options in your menu i would figure that you do not have the common fl231 fuse problem....Now is any part of the picture good. is the picture a bow tie. if you go into red and blue manual option will the crosshairs move up and down and left and right. If you have the bowtie or push in fromtop and bottoml then the likely problem is what is call the convergence power board. if you do have some control over the crosshairs then it may be the convergence amp board. convergence is controled by three diffrent cuicit boards. if you have to replace these boards it may just may need someone like a tech to do a serivce convergence.

yes you have defective convergence circuit!