Fuji finepix s602 horizontal banding

Hi.

You can download the software from Fuji's support page. Please click on this link.

Hope this helps.

Click on the link below to download Fuji FinePix S602 webcam drivers and the FinePixViewer Ver.5.5 Updater software for Windows 7, Vista, XP, & 2000:

http://www.fujifilmusa.com/support/ServiceSupportBrowse.do?prodcat=471517&sscucatid=664260

You should replace the magenta developer M6090.
There is a little bit of disassembly required, but it's not too bad.
Be careful if you are using 3rd party toner, because it's often the cause of this issue.
Whit
Item, Inc.

Try to perform a print head alignment.

You shouldn't need a driver for xp and above as it will be detected as a generic card reader..(As per the manual information)

Having said that there is a driver available from the Fuji site..

http://www.fujifilm.co.uk/consumer/digital/digital-cameras/legacy-cameras/finepix-s602-zoom/support

I remember finding this confusing when I was looking for a driver for my S602

change your magenta led it sounds like that may be faulty big job if not theat then its a new rip baord which is under the cover

Since you can see it when taking new pictures but not on old photos then that suggests that the part of the image sensor is faulty. I think this would make it a camera repair shop job as the S602's can't be taken to bits easily.

I have the same problem. Here's the advice I found somewhere on the internet:

If a jet (nozzle) in your cartridge has gone bad you will see horizontal bands and/or white streaks in your print. Print characteristics may appear incomplete and/or the filled in areas on may not show up.
1) Run some warm water over the print head. This can wash away any ink which might have dried in the cartridge print head. Dry the cartridge with a lint-free cloth before placing back into the printer.

2) Clean the contacts on the cartridge (the copper colored circuitry) and the contacts where the cartridge clips into the printer with water or alcohol. After cleaning, insert and remove the cartridge from the printer a few times to be sure you have a good connection between contacts on the cartridge and the printer.

3) If your print is smeared cleaning the wiper blade may fix the problem. Do this according to your printer manual instructions.

Hello, My name is Richard and I am part of Dell's Online Community Outreach group. Looking at you monitors issue; it would be most advantageous that you contact our technical support. Your monitor seems to be a fairly now model and is probably still under warranty. Call 1-800-WWW-DELL and provided the technician the PPID number on the back of the monitor. The Dell rep will be able to determine your warranty options. Regards, Richard B Online Community Outreach

If the test patterns are not matching what your printer tells you is normal and your photos are banded horizontally, you may have clogged nozzles and printhead. Do a maintenace clean under your printers direction, and see if it now prints ok. Also, you may be low or out of one particular colour, but still have enough of the others and the printer will try to compensate by using available colours, hence colour banding and distortion. A manual clean with cotton buds and cleansing solution is recommended if the first clean does not help.