Question about Pioneer DEH-P7500MP CD Player
More likely is a bad CD servo mech that needs to be replaced or repaired. Sometimes yes, it can be cleaned because dirt will get in their and disable the mech from functioning properly.
Posted on Apr 09, 2006
This might be casued by dust and dirt on the lens. If you can get the top off and get at the laser then a small paintbrush would clean it up nicely.
Posted on Apr 05, 2006
SOURCE: PIONEER DEH-P7500MP
Ok so I just fixed my problem. Although I was getting the error because of using an iPhone instead of a CD I believe it is the same solution.
As jjgomex suggested it was pulling to much power, to what I did was turn on the headunit switch the source to something other than what causes the problem.
Then go to the Audio settings in the menu and turn bass all the way down and Sub Control to -1.
Then turn off headunit and turn it on again and switch to the source of problem, it should be fixed, or at least it did for me.
:) Good Luck!
Posted on May 09, 2008
SOURCE: PIONEER DEH-P7500MP is there a
CLICK HERE for your user manual
There is a small hole just big enough for a paperclip on the face of the radio (when the faceplate is removed)
Press and hold for at least 3 seconds.
Alternately, disconnect the power wire for 10 minutes.
Posted on Jan 16, 2009
SOURCE: I needa user manual for a Pioneer DEH P7500MP car
u need an ingition on hot (only when ignotion is on not when off) *is red*
then u need a constant hot and *is yellow*
then a ground *black*
then hook up your speakers
Posted on Sep 27, 2009
1,665 views
Usually answered in minutes!
hi mate cleaned the laser but no joy
sorted it out it was a transister wich controlls the vd voltage thanks for all the help lads
×