Question about Kodak DC200 Plus Digital Camera

1 Answer

Kodak DC200 Digital Camera

The door to the battery compartment opens slightly and won't get contact with the batteries so I can't take pictures. Do you know how to get the battery door to tighten up so it will get contact with the batteries? Thank you

Posted by Victoria Mahan on

Ad

1 Answer

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points
    MVP:

    An expert that got 5 achievements.
    Governor:

    An expert whose answer got voted for 20 times.
    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 124 Answers

If camera is still under warrenty, kodak will replace the dor for you. if not, i guess you will have to use creative solutions suck as velcro tape, or a rubber band to hold it togegher.

Posted on Mar 26, 2006

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Battery replacement J-10A
Good Morning Fhaas153

Looking at a J-10 picture on eBay
http://www.ebay.com/itm/VINTAGE-CASIO-J-10-ELECTRONIC-CALCULATOR-8-DIGIT-TESTED-/331587643662 , the picture of the rear says '1.5V battery x 2. Looking at this other shot
http://www.casio-calculator.com/Museum/Calculator/FGHIJ/J-10/Casio-J-10-back.jpg It looks like there is a fairly clear Slide-to-Open Battery door at the top of the rear panel. Given the battery rating at 1.5 Volts and the door size, I'd suspect it'll take either AA or AAA batteries. You should be able to slide the door and look, and most battery compartments will have an indication of the specific cell.

To be sure I'm covering both the what and the how, slide the door open. Remove old batteries if still there. Clean up contacts with a bit of fine steel wool if they are corroded or covered with old battery fuzz. Put new batteries in - negative end towards the coil springs generally. Replace sliding hatch.

Hoping this covers what you're looking for!
D

Dec 09, 2015 | Casio Office Equipment & Supplies

1 Answer

Camera wont turn on after charging battery
Always be sure the battery is charged and suited for your camera.
Check contacts of the battery and in the battery compartment of your camera. Dirty or oxidised contacts can be cleaned with a dry cloth, Or a cotton swap. Never use sharp tools to clean contacts or anything in or on your camera.
Always charge the battery before using it for the first time, or if you have not used it for a long period. 3 months is a very long period.
Also check if the battery door is closed correct. Most cameras do have a switch connected to the battery door. If the switch does not work correct, it could be you can't switch on your camera.
If you have a multi meter, you can check your battery. After charging the voltage should be higher (few tenths of a volt) than the voltage printed on the battery.
If the voltage is slightly lower, you know there will be not enough left when the battery needs to deliver some power.

May 20, 2014 | Panasonic Lumix DMC-FZ7 Digital Camera

1 Answer

I have tried two different batteries and niether of my cameras will work. DSC-W80
Always be sure the battery is charged and suited for your camera.
Check contacts of the battery and in the battery compartment of your camera. Dirty or oxidised contacts can be cleaned with a dry cloth. Never use sharp tools to clean contacts or anything in or on your camera.
Always charge the battery before using it for the first time, or if you have not used it for a long period. 3 months is a very long period.
Also check if the battery door is closed correct. Most cameras do have a switch connected to the battery door. If the switch does not work correct, it could be you can't switch on your camera.
If you have a multi meter, you can check your battery. After charging the voltage should be higher (few tenths of a volt) than the voltage printed on the battery.
If the voltage is slightly lower, you know thee will be not enough left when the battery needs to deliver some power.

Jan 27, 2014 | Sony Cyber-Shot DSC-F707 Digital Camera

1 Answer

Will not turn on
I assume you still can view and download the pictures from your camera to your computer.
When you have trouble charging the battery (ies) ready the following, because batteries get old and stop working. Sometimes they work for 10 years, but there are also batteries, that don't last one year.
Always be sure the battery is charged and suited for your camera. Check contacts of the battery and in the battery compartment of your camera. Dirty or oxidised contacts can be cleaned with a dry cloth. Never use sharp tools to clean contacts or anything in or on your camera.
Always charge the battery before using it for the first time, or if you have not used it for a long period. 3 months is a very long period.
Also check if the battery door is closed correct. Most cameras do have a switch connected to the battery door. If the switch does not work correct, it could be you can't switch on your camera.
If you have a multi meter, you can check your battery. After charging the voltage should be higher (few tenths of a volt) than the voltage printed on the battery.
If the voltage is slightly lower, you know thee will be not enough left when the battery needs to deliver some power.

Jan 11, 2014 | Nikon Cameras

1 Answer

No coming on when battery installed
Always be sure the battery is charged and suited for your camera.
Check contacts of the battery and in the battery compartment of your camera. Dirty or oxidised contacts can be cleaned with a dry cloth. Never use sharp tools to clean contacts or anything in or on your camera.
Always charge the battery before using it for the first time, or if you have not used it for a long period. 3 months is a very long period.
Also check if the battery door is closed correct. Most cameras do have a switch connected to the battery door. If the switch does not work correct, it could be you can't switch on your camera.
If you have a multi meter, you can check your battery. After charging the voltage should be higher (few tenths of a volt) than the voltage printed on the battery.
If the voltage is slightly lower, you know thee will be not enough left when the battery needs to deliver some power.

Jan 09, 2014 | Canon IXUS 80 IS Digital Camera

1 Answer

It turned off for no reason. The batteries were new.
Check door release mechanism. Or check contacts inside battery compartment. Rechargeable batteries (NiMH) have been known to be slightly larger than normal alkaline batteries, so check to see they are making connecting with the contacts by pushing batteries all the way in

Nov 29, 2013 | Cameras

1 Answer

Display screen not light up
Are yo using a stock Nikon battery or an aftermarket brand?? Nikons cameras are all famous for their batteries not staying in their compartments tight which means your battery in not getting a good, solid connection. Open the battery compartment and put a tiny piece of folded paper on top of the battery (on the end where you close the door, not the side with the contacts) and then carefully close the lid, this will create more pressure on top of the battery making a stronger contact. Hope that helps.

Oct 13, 2013 | Nikon D Cameras

1 Answer

My keyless entry pad will let garage down when code is keyed in, but when code has been keyed up to let it up it will not do so.
I assume you mean that the entry keypad works when the door is open but not when the door is closed. This usually indicates that the signal strength on the entry pad is low. Try changing the battery.

Insert a small Philips screwdriver in the opening on the bottom of the battery compartment cover. Pull the cover slightly outwards then pull the cover down. The battery in the compartment is a 9V battery. Then replace the cover by inserting the lip in the top of the battery compartment and then snap it into place.

If you change the battery quickly, you shouldn't need to reprogram the opener. If a new battery doesn't solve the problem, check what may be causing signal interference when the door is down. (Consider moving the keypad to a spot closer to the door opening. I know that we have the keypads placed on the side of the door jamb on our garage doors. When the small handheld remote units start to loose their batteries, bringing the remotes to that area that often works.)

I hope this helps.

Cindy Wells

Oct 04, 2013 | Sears Craftsman LiftMaster Chamberlain...

1 Answer

Have a 4-5 yr old Canon S2 IS PowerShot A75 Digital Camera. The batteries are new &/or charged but the camera won't always work reliably - says to change batres. but if I just open the bat. door...
Sometimes, the lower contacts get bent downward after years of use, causing the batteries to ride low in the compartment, and thus making poor contact when the battery door is closed. Try lifting/bending these interior battery contacts upward, so that the batteries ride higher when inserted.

Oct 29, 2011 | Canon PowerShot S2 IS Digital Camera

1 Answer

Wont turn on
Good morning, afternoon, evening or night; whatever time of day you are viewing this solution post. Thank you for choosing FixYa to assist you. You are having problems because you calculator won't turn on. I think you should try changing the batteries. Did you know that your calculator has two batteries powering it? Not only are the 4 AAA batteries powering it, but there is also a CR 3V Lithium Back Up battery powering it as well. First, try changing the 4 AAA batteries. If that still does not power your calculator properly, you will need to replace the lithium back up battery. You can find this at a department store or store that carries electronics. To do this, open your regular battery compartment. Above the AAA batteries is a compartment that says "BACK UP BATTERY CR1616 OR CR1620" with a picture of it. Use a small crosshead screwdriver to open the compartment. Take the old battery out and replace it with the new one. Rescrew the lithium battery compartment back on and close the AAA battery compartment. Turn on your calculator and see if that works. I hope this solution solves this.

Sep 27, 2011 | Texas Instruments TI-83 Plus Calculator

Not finding what you are looking for?

View Most Popular

DC200 Plus Digital Camera

  • Cameras

Related Question

Battery replacement J-10A

  • Casio Office Equipment & Supplies

Open Questions:

0 Answers

How do I get a full screen shot of my photos on my Echo Show

Dec 16, 2020 | Cameras

0 Answers

My grand daughter has an ITEK BIG drone, no camera, nothing fancy but I need instructions how to do one button return and headless mode. Cant find them online ITEK Big drone manual?

Apr 03, 2020 | Cameras

0 Answers

My charger for my i85 camera keeps blinking yellow when I plug it in is it my battery bc I cant turn on the camera

Apr 02, 2020 | Cameras

0 Answers

I have andoer hdv-z20 camera.i put 64gb memory card and it always says storage media.please tell solution

Mar 30, 2020 | Cameras

See all Kodak DC200 Plus Digital Camera Questions

Related Topics

Kodak DC200 Plus Digital Camera Logo

Related Topics:

80 views

Ask a Question

Usually answered in minutes!

Popular Questions

1 Answer
What kind of battery can I buy for my M580 Kodak easy share?

Kodak Easyshare M580 Digital...

5 Answers
Cannot transfer my internal memory photos into my sd memory card

Kodak EasyShare Z740 Digital...

3 Answers
"Unrecognized file format" error message

Kodak EasyShare One Digital...

19 Answers
Kodak EasyShare M853 Digital Camera lens error 122,1,0,0

Kodak EasyShare M853 Digital...

2 Answers
Kodak dx 7590 camera will not format a memory card?

Kodak EasyShare DX7590 Digital...

Top Kodak Cameras Experts

Cindy Wells

Level 3 Expert

6259 Answers

Brad Brown

Level 3 Expert

18665 Answers

Steven Wander
Steven Wander

Level 3 Expert

595 Answers

Are you a Kodak Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
. DC200 Plus Digital Camera Manual

DC200 Plus Digital...

Loading...