My printer will not print. The status says out of paper, but there is paper loaded in the bottom

There are various responses regarding the operation of the printer on the Omni. Use the following to guide you through resolving this problem. Terminal Response Probable Cause Action Taken No Receipt
Prints Terminal is out of paper. Load paper and/or verify that the paper is installed correctly. Motor on printer is defective. Have terminal serviced. For Vx-6xx terminals only, insufficient charge remaining in the battery to complete the print operation. Check battery status and recharge if neccessary. Receipt Feeds,
But Nothing Is
Printed On It Not using thermal paper. Ensure thermal paper is being used. Thermal paper loaded upside down. Ensure thermal paper is being fed from underneath the roll, as it will only print on one side of the paper.

Hi,
Here's how to clear the paper jam,

• Open the paper tray and remove all the loaded papers.
• Open the printer cover and check through for any stuck papers and remove them manually.
• Close the cover and turn the printer off.Wait a few minutes then turn it on.

Now try to run a status print by:

• Turning on the printer.
• Load a paper
  
• Press the right arrow > three times.
• A status sheet is printed.

Hope this helps.Thanks!

The picture of paper with a corner folded down is Load/Remove paper. Can you describe the status lights of the printer? The light sequence will indicate specific error and status of the printer.

For further assistance, please contact Lexmark Technical Support.

You need to program the paper size for the trays

IP4700 series has 2-way paper feeding. Please check you paper feeding from bottom cassette or rear auto feed!
Before perform the printing job, you may notice on your printer right side can select paper feed from rear or bottom.
Enjoy printing.

Hi, Please follow these steps to load :-
1.Turn on your printer. Make sure it is in ready mode (green status light on) and it is not printing or running any other operations.

1. 2.Determine whether your printer uses a top-feed or bottom-feed. Blank paper stands upright in a top-feeding printer and lays in a tray on a bottom-feeding printer.
   3.Load your envelope in portrait mode for envelopes that are 8.5 inches wide (standard paper size). Fold the flap down and place the envelope with the side to be printed on facing you. Load the envelope so that the side with the flap enters the printer first.
   4.Load your envelope in landscape mode for longer envelopes that cannot fit in lengthwise. Close the flap. Load the envelope so that the left side enters the printer first (the flap will be on your left).
   5.Set the paper guides. This guide is the sliding piece on your feed tray (it will usually be on the left). Slide it over so that the paper is held straight when it enters the printer.
   6.Set up your printing preferences. Go to "File > Page Setup" or access your printer’s properties page. Under orientation, select portrait or landscape mode depending on how you loaded your envelopes. If your printer has this option, select “Left” for bottom-feeding printers and "Right” for top-feeding printers
   7.Take a look at the "Print Preview" (usually found under "File" menu) and make sure everything looks good. Then print.
   
2. Thanks!
   

If the ink light is on steady red, that means the black or color ink cartridge is nearly empty. Obtain a replacement black or color ink cartridge. To know which cartridge is out of ink, check the ink levels using EPSON Status Monitor 3 (Windows) or EPSON Status Monitor (Macintosh). If you just replaced the cartridges before you got the error light, that means that the replacement cartridge is not recognized by your printer. Please reseat cartridges. Then turn the printer on and off. The cartridges maybe bad also.
If the paper light is on steady red, try to reload 10-20 sheets of regular paper into your printer. When printing on CD/DVD, CD/DVD tray is not inserted in the printer. Insert the CD/DVD tray in the printer and press the paper button.Could also be that the printer has loaded more than one sheet of paper at a time. Load paper in the sheet feeder, and then press the paper button to resume printing. If the CD/DVD guide is open, close the CD/DVD guide, load paper and then press the paper button.

try by reinstalling the drivers, if the printer gives the same error then your printer need to be serviced

seems that y´all experiencing various paper feeding issues
check first for recommended paper type

that printer should handle 4x6´s up to 8.5x11´s
and if it can´t feed a particular size - hardware issue & check your warranty status with the manufacturer

To fix the NON EXISTANT paper jam:

Status light is on, paper light is on - you can hear the paper feed trying to "grab" the paper, but it can't,  and status light goes Red.

Take out paper tray

Reset the blue paper holders, move them tight against the paper so the paper is snug against all blue barriers. Cause: Somehow the blue paper holders got dislodged and the paper is not snug so the feeder is trying to grab paper that  is slightly out of reach.