EACH TIME I TRY TO ACCESS MY SAMSUNG E250 CAMERA THERE IS ALWAYS A FEEDBACK WHICH SAYS PLEASE SLIDE UP EVEN THOUGH I HAVE DONE SO WHY IS IT SO ? PLEASE I WANT A SOLUTION NOW

It is likely the phone has a defective control circuit for the alarm. Maybe it's time for a new phone.

Hi there please follow the steps and let me know the result.
1. Ensure batteries are fully charged & clean the battery connector point in side the battery compartment.
2. Look carefully between the lens and the camera body for any sand, dirt or any damaged etc.
3. Try turning the camera with the lens facing down and shake to dislodge anything stuck
4. Try removing batteries and memory card, wait 5 minutes and refit the battery only.
5. Now turn on camera( with out card ) and see ,if working then fix the memory card & again turn on the camera. If working then fine . Otherwise format the memory card and fix back in camera again & try. Make sure before format the memory card take a back up all photos in your computer then format. If no luck then reset or restore the camera setting by pressing Menu key for 2 sec .. in not done the press both Menu & self time key for 2 - 4 sec.
i hope it will gives you success. Thanks & Before you leave, if you have found my information helpful and if you haven't already done so then please press the ACCEPT button, this is how I am paid for helping you today. POSITIVE feedback & bonus is appreciated

when i open camera it say please slide up

i want to known why my samsung e250 phone camera is not working anytime i try to take picture they will say please slide up

* go to settings
* go to sound settings
* now go to 5th in the list i-e; slide tone
* select your desire tone and set
* you are done =))

jst contact ur service provider nd ask them for settings for ur mobile handset nd ur work is done......

*2767*2878# use dis code if der iz any sort of software problm its gnna ok...
if u fellin same problm den its must b strip problm and dats hardwre visit any hardware expert

That one time happend to me. I plugged it into another port, and it worked fine.

Please forgive me if I am being stupid but those 2400ah batteries have to be charged before use - I assume that was done.
The first thing I would have done would be to try another set of alkaline batteries as the originals could be discharged.
This is solution is probably too obvious to be true but then you never know.

Has it always done this or only since you started standing on your head?