Stopped printing I have a 300LP and it is fine (less than 6 months old). While priniting it stopped and a red light came on. there is no paper jam, plenty of ink and nothing I can see that is blocking it but everytime I turn it on and off it goes back to the blinking red light (small) and constant red light near the stop button. What is keeping me from printing? Barry Moore

For me on my Cannon MX410 with a "paper Jam" light displayed this WORKED!! The absolute BIZZARE thing was after I went and through the described procedure above and rebooted and tried to print the 1st page that came out had a "crushed" ****-roach on the 1st page! So I didn't have a paper jam,...but a
ROACH Jam. :) I told my wife, Humm pest service not workin I guess! It errored out again, but simply unpluggingUSB and power cord (not the steps described for the Print Spooler) it prints fine. SO saved me buying a new printer which was just 6 mos. OLD and FINE by me! So THX, Vikram Kumar Thumu!

Great job on removing the paper jam and trying it with a different paper. If you have already tried using different media, using 1sheet or multiple sheets on the feeder but still no difference, most probably a mechanism problem in the printer. If this is the case, I strongly suggest you contact Lexmark Technical Support to further investigate the problem. A 6-month old printer shouldn't cause you that much trouble.

My C60 Epson Stylus printer is not printing. First of all the paper jammed, I pull the paper from the front and since then the catridge holder is not going to the middle to print. also the green light keepon flashing and the red light stays on. I need your help.

Ok, fine May be Ur paper rolling head iz covered with dusty substances.
try to clean it and then try 2 print it.
Bye

there would be little bits of paper jamed inside the printer, now wnen ever you tries to take a new print at that time the bits of paper blocks to come out..........just open the printer and clear off the papers

try to add some paper to the tray ..maybe the paper pick mechanism has been failed..

A paper jam has occurred. To solve the
problem, see “Clearing Paper Jams” on
page 6.3.
• The front or top cover is opened. Close the
front or top cover.
• There is no paper in the tray. Load paper
in the tray.
• The waste toner container is not
installed or full. Check the container.
• Your system has some problems. If this
problem occurs, contact your service
representative.

• Also i can indicate that the Toner Cartridges are empty and need replaced with Genuine Samsung Cartridges
  

opn the printer and take out the tomer and see that any peice of paper or any other object is jammed and check the paper roll area also , and check the toner also whether it is empty or not

Hi! I have the same issue. The only solution I still use: select print from document with no paper in the hp's feeder. Let the printer go on "paper out" message, now put the paper into the feeder and press the print button on the printer. Success!

Placing one sheet at atime is worse usually as these units feed off a minimum level. Keep them topped up to at least no less than 10 sheets. The printers sound like the have a paper feeding issue. Could be a jam. Open unit, check for paper jam. Cheers lilacgerry xxx