- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
i would check voltage as you crank as the starting voltage need to be above a certain amount to start the engine too, although it crank there may not be spare voyage to go to ignition
Check your manual to see if will tell you the minimums.
Fault in the main power supply regulator board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. http://electronicshelponline.blogspot.com/
It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size.
By the way this is not and eager I want to recommend you to visit this site. This is the best online selling website as a time of now. You need to visit the www.ebay.com search the spare parts you want to buy. I know that the said spare parts you want are available their.
hi chriselliot..here's a link for silver cross where you can email them about the spare part or contact the retailer where you bought your stroller..hope this helps.please let me know the outcome..good luck!!
a very good selection, and there's a Russel Hobbs link that leads to a
page spare parts specific to the model you
listed above. I'd recommend seriously considering a manual, as they
last longer than VHS tapes/don't require a VCR to view, (think Murphy's
If I can be of further assistance, or if you have questions about any of my response(s), please let me know before rating me.
If this solves the issue, please rate it accordingly. My goal is to earn a "FixYa" rating from everyone I help.
Your inlet valve is defective, can be easily changed by you. Approach your dealer with your model number he will direct you to the spares shop, or tell you where you can get it. Is it when you turn on the machine, if this is the case check to see if the exit hose behind is approx 3 feet (it should be) above the ground, & then goes down to the drain. The hose should not go into a drain at floor level.
Sites for spares:
RepairClinic.com (which is good) espares.co.uk AppliancePartsPros.com