What is the feather on right side of my garmin for?

Check your vehicle connection.
Contact your local service center directly or online here:

A manual and troubleshooting guide for your camera is available here.

Carbs need to be cleaned and boots between carbs and block might have rips in it. Sucking to much air. Also check reed valves for ware

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589

This generally involves the use of a "plucking machine". After the chicken runs through the kill line, it is submerged into a hot bath of water in order to losten the feathers. The bird is then taken through a plucking machine which has rows of rubber "fingers" spinning on each side which pulls the wet feathers from the body of the bird. A constant stream of water washes the feathers down into a collecting pit for disposal.

You don;t need to register it but if you want you just go to Garmin's website and register your device.
Just click on the link and towards the lower right side is the register your product button.

http://www.garmin.com/us/

Hit Mode till you see History,Training,Navigation, and Setting. Scrol to Settings using the down arows on the right hand side of the watch. On the same side of the watch hit Enter.
Hit enter on General.
Scroll down to Units (You can't see it right away, you have to scroll down) hit Enter on Units. There you can change to Metric.

hello. Begin by turning the volume all the way on. It is the little dial on the upper right side of the garmin. If that doesn't give you sound, return the unit as it is under warranty.

If you are looking for an owner's manual for your Garmin product, it should be available for download at www.garmin.com. Go to the site, find your unit and look for Quick Links on the right side of the screen. You should see a tab for "Manuals". Try this.

I hope this helps, I had the same thing happen today. I noticed on the face under the word Garmin you can pop the face off and underneath on the right side is a reset button I held it down for 10 seconds popped the face back on and pressed the power button it came on. I hope this works for you.

You may adjsut the contrast or brightness setting of the camera or you may send in your camera to service center.