How do i put the all purpose foot back , mine fell off

How to install cord on sewing machine foot control

There should only be one way that it will fit so just keep moving it about and turning it till it snaps in place

Assuming you have all the parts, the spring goes inside the little hole in the back of the mechanism.
You then position the lever behind it, line it up with the bar that holds the lever, and put the lever pin back in.
This is very tedious, and can be frustrating. You might consider paying for a new one.

Go to the singer website
Go to the home page
At the bottom of the page look for instruction manual--click on it
It will take you to another page
In the box put the model number (example 3116 ) & click search
They usually have a free download

check on page 16 about the foot

take the presser bar lifter & lift it up, if you look close it has a small notch under the front
place the all purpose foot down under the presser bar, make sure the presser bar notch get on to the pin that's across the top of the purpose foot & they should snap togeather

There should be a little **** in the back of the pressure foot bar that you cut the thread on. It normally is about an inch above the pressure foot attachment screw running horizontally.

Elna also bought out a a little black pressure foot screw/combination thread snip that replacded the silver thumb screw holding on the pressure foot shank which serves the same purpose. You wind the thread around it on the left side into a spring loaded crack and pull, it cuts and holds the two ends.

Failing that, a cheap pair of thread snips is another way to solve the problem.

If, you read your book you will see how to do it. And if, you do not have your manual, go to www.brother-usa.com, under support, click on home sewing and embroidery, then select your model, and just below you will see your manual to download. That is free. The reason that I couldn't answer you was because you the foot fell off, did you mean the snap on one or the snap on foot adaptor? If, the book does not work for you write back.

It looks like you just screw it on. It had to be loose to begin with. If, that isn't right, call Brother at 1-877-276-8437 and ask them. To me it doesn't look any different than a regular sewing machine foot. Good Luck

Mine feel off too. need diagram or something showing how to put it back on. email me at [email protected]