Question about LG LDS4821ST Stainless Steel 24 in. Built-in Dishwasher

1 Answer

Dishwasher door leaks when in cycle. we purchased our dishwasher last year and have started to have problems for the last 5 months. Is there a recall

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

I have the same problem with model # lds4821ww. Seems the diaphram on the fan housing get dried out and causes it to leak down thru vent tube. Easy to repair just have to get part.

Posted on Nov 30, 2011

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

For no apparent reason that I can seem to find, the dishwasher periodically has the bottom full of water. It is not that a cycle was interrupted. It happens between uses. It is clean water and does not...


You seem to have a leaking inlet solenoid valve. It could be a bit of dirt stuck across the seats but it could also be the valve seats that have cracked or worn. Check the valve and replace it if necessary. It is the first component after the inlet pipe.

Feb 06, 2011 | Whirlpool Dishwashers

1 Answer

I have a du1030xtxs1 dishwasher that will not even start filling. The door latch switch, over fill switch and fill valve seem to be okay. I tested the wires coming to the fill valve by disconnecting them...


Yes, probably a control board, or wiring to the valve from the board. Call Whirlpool with your model and serial number, if the manufacturing date is within the last year, they will cover the repair without a date of purchase. Or you can contact the seller and see if they have a date of purchase for you. Good Luck, Appliance Specialists

Dec 16, 2010 | Whirlpool DU1030XTXS Dishwasher

1 Answer

Door leaks at the bottom of my ge profile dishwasher


1 has the machine been pushed into the cupboard hole,this will push the door away from the front of the machine,does it hit the trim around the opening before the closeing?pull out check under are the legs still straight,some you can remove the lower front panel to look under

Dec 02, 2009 | GE Profile PDW8400J Built-in Dishwasher

1 Answer

After it fills and starts to wash my dishwasher


Reseat the little rubber gasket along the door. Pull it out a little bit

Aug 16, 2009 | Whirlpool DU930PWS Built-in Dishwasher

1 Answer

Maytag MDB7130AWB dishwasher blows circit breaker.


These have been known to leak water into the door panel. If so the water can cause a short. Your breaker is keeping the machine from lighting up. Check any seals that may have been braeched in the door. Start at the dispencer latch
rubber.

Mar 07, 2009 | Maytag MDB7100AWB Dishwasher

9 Answers

Kenmore Elite 17483 Dishwasher Caught Fire!


Had the exact same problem (Control panel burning up, sparking, and smoking during wash cycle) last night with our Kenmore Elite DW model 665.16293400 purchased Nov. 2004. I have reported it to the CPSC and www.kitchenaidfire.com and will be contacting Sears first thing tomorrow. It is outrageous that this problem is apparently so widespread with nothing being done about it! I have no doubt my kitchen would have been in flames if I had not been sitting right here to shut off power to the D/W.

Feb 04, 2009 | Kenmore 24 in. 17483 Built-in Dishwasher

2 Answers

My portable danby is stuck on the Drain cycle


take bottom front panel off to expose bottom tray and you will probably find it full of water. disconnect from electricity and mop water out and machine should work. if fault reoccurs then you have a leak

Sep 25, 2008 | Danby DDW1805W Designer Series...

1 Answer

Wont start


Give it a firm push over the door latch once you've closed the door..it might be the door switch not activating. oops.... first and formost isolate from power for 5-10mins and try

Dec 28, 2007 | Bosch 24 in. SHU43 Built-in Dishwasher

1 Answer

2-yr old unit is leaking


I had this problem with similiar model, the extended warranty company was out several times, replaced gaskets and many other parts. Still had the problem. The last tech replaced the upper washing arm that hangs below the upper rack, He said there was a defect where water shoots out between the mfg welded seam and shoots water at the door in the right spot to make it leak. He replaced it and haven't had the problem for about 8 months.

Nov 26, 2007 | Frigidaire 24 in. PLD3465REC Stainless...

4 Answers

DISHWASHER IS LEAKING A LOT OF WATER


I had the same problem with my machine - ie lots of water coming out front about two thirds of the way through the cycle - engineer (local and very reliable) knew as soon as he came in that I had started bying Powerball 5 dishwasher tablets - they produce too much foam (try opening the door during the cycle and see the amount of foam) and it therefore comes out of the overflow parts on the door. I tried Magnum 5 and got the same problem. Now I stick to either Asda's own basic (not the 5) or I buy the Magnum ones and cut them in half. Has never leaked since!

Jun 11, 2006 | Hotpoint 24 in. FDW60 Free-standing...

Not finding what you are looking for?
LG LDS4821ST Stainless Steel 24 in. Built-in Dishwasher Logo

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top LG Dishwashers Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Mike

Level 3 Expert

4369 Answers

Lollo Pop

Level 2 Expert

134 Answers

Are you a LG Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...