DYSON washine machine fault

hi sathiya.
see if this link helps you out.
Dyson cr01 fault find f11 Google Search

normally error like this disappear when a hard reset is performed? did you leave the unit turned off by plugging out from wall power for one night ??

until what cycle does this unit proceed?

Dyson Memory CRO1 Front... Fault f11 Solutions - Fixya

www.fixya.com > ... > Dyson > Dyson Memory CRO1 Front Load Washer
Dyson Memory CRO1 Front Load Washer, fault f11 related issues. Get free help, solutions & advice from top Dyson experts.

may be the rear bearing has gone,my con/rota packed in and i took the drum out cleaned ,replaced, greesed, and alls well , if it is the rear bearing DON"T let them tell you its scrap if you are good at diy you can take the bearing out and fit new one, bit of a time comsumeing job

Get Dyson out, the powerboard has failed, don't be fooled into thinking replacing the fuse on the board will do the job, it doesn't, a component has failed on the PCB which has caused the fuse to blow in the first place, £95 call out i'm afraid.

Hi,

Please find the steps that needs to be taken for trouble shooting F11 fault code specially if there was a power cut.

1, Power off at the machine. Do the next 4 steps within 3 seconds.
2, Press Temperature Button in.
3, Power on
4, Release temperature button
5, press Soil Type button

You will now hear the door lock release so you can get to your pants.

Diagnostic code is now displayed. You can switch the washer off and back on and the error code is clear. If you do this it will work.

I am sure it would help you to resolve the issue.

God Bless.

f11 fault code is a problem with the main power board (could be blown fuse) or a blown board check the fuse the board is behind the back plate in the bottem right corner (looking from the back of the machine.(!unplug before you take apart!)

To Clear F11 Code after a power cut.

1, Power off at the machine. Do the next 4 steps within 3 seconds.
2, Press Temperature Button in.
3, Power on
4, Release temperature button
5, press Soil Type button

You will now hear the door lock release so you can get to your pants.

Diagnostic code is now displayed. You can switch the washer off and back on and the error code is clear. If you do this it will work.

Thanks for using Fixya.

To Clear F11 Code after a power cut.

1, Power off at the machine. Do the next 4 steps within 3 seconds.
2, Press Temperature Button in.
3, Power on
4, Release temperature button
5, press Soil Type button

You will now hear the door lock release so you can get to your pants.

Diagnostic code is now displayed. You can switch the washer off and back on and the error code is clear. If you do this it will work.

no.needs engineer