Top 20 Razor Dune Runner 350 Go Cart Questions & Answers

fuel system over fueling needle and seat not operating correctly if carby air/fuel sensor if injected plug replace with new plug and gap correctly

are you sure that the charger is putting out enough volts to charge the batteries? check the charger with a multimeter, then check the batteries with a multimeter, and viually inspect the batteries for bulging

Most likely that is going to be a battery problem. You have plenty of volts but insufficient Amperage to turn the motor over indicating there is a Dead cell in the battery you currently have. The problem with these smaller batteries is they develop memory quickly and don't respond well to being left on a charger year round when that is done. When stored the best way to maintain the battery is to find a way to put it under a load every couple of months and then recharge. Simply connecting it to a charger or allowing it to sit on bare concrete, even during charging, is bad for lead based batteries. When not installed on the vehicle it should be stored on a piece of wood to prevent ground contact or grounding.

Maybe the battery inside is swollen or faulty and needs to be replaced

Question edited for clarity. Hello again Cindy, I gave you all the information on this a few days back. You need a competently inclined person with a multimeter. The circuit is simple. You have two 12 volts batteries in series which makes 24 volts. You have a hand controller which is a variable potentiometer like a volume control, which feeds voltage to the motors. The controller module tells you the battery voltage level and probably has a couple of relays. Check the battery wiring again, you should have a wire coming in to the plus on battery 1 and the negative on battery 1 should go to the plus on battery 2. The negative wire from battery 2 completes the circuit out. Do you know your charger works? That can be checked with a meter as well. Get out your multimeter and check the TOTAL voltage plus on battery 1 to the negative on battery 2. You should have 24 volts, 2 x 12 volt batteries in series. Take them both off and charge each one on a car charger set at 2 amps for about 4 hours each battery. Clean all the battery connectors with a wire brush and also the connectors. Smear them with Vaseline. Also make sure you have the batteries wired up correctly. If done incorrectly, you may be running on 12 volts which is why is is showing 'Low Voltage'! https://www.google.com/search?q=razor+quad+low+power ..

Model number that has four wheels is ................................

so what had been hapening is that it could die depending if it was the battery that could aftfect with this. 24 volt battery, and can be ridden for up to 45 minutes after battery charging. The charge time recommended for this Razor electric scooter is about 10-12 hours after each use.

Hi there, charging normally takes approx. 16 hours. Do not leave the appliance connected to the mains for more than 24 hours. I have included a link for the user manual for this product.

https://www.youtube.com/watch?v=nu8TbterSqs https://www.youtube.com/watch?v=nu8TbterSqs https://www.youtube.com/watch?v=U5bLxlCmKRU https://www.youtube.com/watch?v=IpLxb4TneBk

Yes it is

The Razor 13013290 Air Scooter's frame is made from aluminum steel which is strengthening strongly. This is why you can use the scooter for a long time.Click here for more details complete Razor 13013290 Air Scooter review

Hello Before you change the battery check thoroughly all wires and all connections!!!!

Betcha the battery is ng!!!!!!!!!!!!!!!

Sounds like the battery is defective.

Connect to the battery.

Question edited for clarity and spelling of the maker, 'Spaulding'.

Manuals Page

Spalding.com https://www.spalding.com > customer-service > info > m... Systems Manual Finder. You will need your model number to locate the correct manual. Please follow the steps below or visit our interactive manual finder. ..

I would contact your service provider for the code.

Check Batteries: Ensure that the batteries are properly inserted and have sufficient charge. Sometimes, a low battery can cause the toy to stop functioning. Switch On/Off: Confirm that the toy is switched on. Some toys have an on/off switch or button that might accidentally get turned off. Connections and Wires: Inspect the wires and connections inside the toy. Loose wires or faulty connections can lead to malfunction. Obstructions: Look for any obstructions or debris that might be preventing the T-Rex's movement. Clear any blockages. Reset: If there's a reset button, try pressing it. This can sometimes resolve minor issues. Contact Customer Support: If none of the above steps work, consider reaching out to Fisher-Price customer support as below. https://service.mattel.com/us/ContactUs.aspx

You use a USB charger lead to charge the battery in the helicopter. The controller takes 6 x AA batteries. https://rc-today.ru/UserFiles/Image/Instructions/-S929.pdf https://www.google.com/search?q=rfd001+helicopter+charging+lead ..

It is too old (1970s) for that data to be on the Internet. There is one for sale on eBay, buy it and carefully look inside. https://www.google.com/search?q=Need+Play+%27N+Learn+Computer+420 ..