20 Most Recent NEC DTU 8D-2 Corded Phone - Page 4 Questions & Answers

Press Feature 69 Feature

To change the names on the NEC Dterm 80.

Feature, Conf, #, 0, *, 8974, LINE 4, 18.

Select Conf to go to the name you want to change.

Select Hold to erase the characters.

Select Transfer to save it.
Once you save, make sure you go back to "18".

extension id is changed in system programming

To Update Time: From operator telephone with receiver hung up; Press feature key; dial 9,#; enter hour and minute i.e. 0135; (press recall key to change from am to pm); press feature key to save and exit.

from that phone hit speaker key dial 42 then hangup

in system programming

If you are using the headset jack on the phone, a headset key needs to be programmed on the the phone. You can do this in program mode and make a line key a headset key. Otherwise you must connect it through the handset. ldtsnj.com

A button must be programmed as a "headset" key. When activated, it will lamp red, and put the conversation on the headset jack under the phone (next to the handset jack).

Or you can purchase a headset with an auto lifter for the handset. It picks up the handset enough to answer the call, but transfers the conversation to your headset.

yes

through your voicemail programming setup.

when the light is lit it allows hansdfree use of your phone.

if you have an elite ipk system,time and date are changed at the attendant position.hit the feature key dial #

whos your phone system provider?

Sorry, but these softkeys are fixed in the display of an idle phone. They cannot be removed.

They need to be corrected in programming. ldtsnj.com

press feature than answer. ldtsnj.com

you need to have the phone programmed to ring. ldtsnj.com can help

The ipk uses sat software. You cannot connect to it via a browser. Only ipk 2 or later can do this. ldtsnj.com can get you what you need.

You need a mif-m card and kmm chip installed in your system in order for this feature to work. ldtsnj.com

you cannot do this at all. ldtsnj.com