Samsung AP500PF Air Conditioner - Answered Questions & Fixed issues
Error code es 54
Did you try a power cycle? I know that sounds like a catch-all answer, but it has worked for me in the past. I had this same air conditioning unit, and it used to give me this code frequently. Flipping its breaker always fixed the problem for me. Good luck.
http://www.a-ccontractors.com/
Compressor will not turn off
Hi, kindly check the thermostat of the condenser. thats why your compressor is not automatically stop due to not reach the actual settings of the temperature. or you have leak on the copper tubing that has freon inside. thanks
What is the appropriate pressure
Lowside psi. should about 60-68 highside about 225-250. This is aproximent pressures as indoor and outdoor tempetures play a big part in determining propper charge.
When we have a power bump the unit reverts back to
Not sure why your unit would reset to factory settings, it's usually the thermostat settings that control the unit and resets when you have a power failure. Most thermostats have a battery in then to power the thermostat during a power failure. They usually only maintain the power from 15 to 30 minutes to maintain your settings, before defaulting back to factory settings. After every power failure you usually have to replace the batteries.
Samsung digital inverter ac c1 error code
The C1 error code on a Samsung digital inverter AC usually indicates a communication error between the indoor and outdoor units. This could be caused by a faulty control board or a wiring issue.
To troubleshoot this issue, you can try resetting the unit by turning off the power supply for a few minutes and then turning it back on. If the error persists, you may need to call a professional technician to diagnose and fix the issue. They may need to check the wiring connections and replace any faulty parts if necessary.
Samsung AQ12FAN, indoor unit starts on it's own, and stops after a few seconds.
Hi,
It could be that the motor for the device needs to "warm up". Everytime it stops the internal thermostat sees that the target temperature has not been reached so it starts the internal motor again. This happens in a cycle until the motor gets warmed up or the target temperature is reached. This is my hypothesis. So, you might need to get the devices's motor checked out. Thank you.
Not finding what you are looking for?