Samsung MU3250W Microwave Oven - Answered Questions & Fixed issues

It's 950 watts.... back of unit says .95kw.... do the conversion ;)

950 Watts. Back of unit says .95kw. Do the conversion ;)

You could have burnt the foil into the bottom of microwave I would take a box razor and shave the area till there is no more foil melted in the bottom

~

If you were to log on to the manufacturer's web site, I think you will be pleasantly surprised as usually one is able to download, by model number, Customer Instruction Manuals, list of Dealers, for spare parts and service, and Installation Instructions as required.

Just Google the manufacturer's name and follow the links. Make certain you are directed to the manufacturer's web site as some search engines direct you to other sites and they charge for the information that is normally free of charge.

I hope this helps.

Could be the magnatron at fault.......Cheaper to renew..

Yes.

it sounds like it one of your micro-switches inside that control the power to the doors, if one of the switches is bad, it would cut the power , the panenl will light, the turn table will work, the fan will turn on , but you will not get any heat at all, micro-switches run depending onthe unit from 5-10 bucks, when you open the unit you will see the one that is bad, is usually bent or the connector might be burn or melt, good luck..!

Yes it just will not cook or defrost very evenly. It is not dangerous however.

Probably the motor or gears that make the turntable go are worn or burnt out.

It could have been steam or humidity.

If this is an over the range model, be sure you always use the hood vent exhaust fan when you're cooking on the stove top.

Whether it's a counter top or over the range top, always be aware that the cooling fan is running when it's cooking.

When in doubt feel for air flow through the vents.

Good luck.

The problem is your magnetron tube is leaking RF. The mag tube comes on 2-3 seconds after you hit start, and the RF interfears with the board and shuts it down. Drop the front of the control panel down and watch, it wont happen.. Get a new mag tube put in and you'll be good to go.

A new keypad is not difficult to install, and can be worthwhile.

It's part # DE34-10139B and you can get one for $18.71 plus shipping from http://www.samsungparts.com

If you or a friend decide to work on it, we have *critical* safety, disassembly, and troubleshooting info at our site, which is linked at our listing here on FixYa: http://tinyurl.com/yzjozk

We're able to install them for folks who don't want to do it themselves.

There are many other components that can fail. A Samsung is worth getting professionally repaired. https://www.fixya.com/support/r29874712-repairing_microwave_ovens ..

where did you buy it?

Judging from reviews of this model on Samsung's website, this is a common problem. Does it happen during or after using the cooktop or range below the microwave oven? In particular, is it most common when using the burner directly under the microwave oven control panel? If the issues are correlated to heat or humidity from cooking on the range top, I would suspect problems with moisture in the keypad circuitry. I would consider cleaning the controller board key panel connector area with 90%+ isopropyl alcohol (this is an internal service on a circuit board that is most likely susceptible to damage by static electricity, so it should be done by someone who knows how to service electronics). This should remove contaminants that could cause current leakage between keypad connections (spurious keypad entries) in humid conditions. Let the board dry thoroughly before reconnecting. It's also possible that moisture is getting into the keypad assembly. This would be a design/manufacturing flaw. I would guess the oven is out of warranty, so the fix would be to put the keypad in a dessicator for a day or so, then seal the edges with RTV Blue or a similar caulk that does not release acetic acid (vinegar) during the curing process. (Acetic acid even in vapor form may corrode the silver contact material in the keypad.) Do not seal the connector, just the edges of the flex ribbon layers where moisture can get into the key membranes. In the meantime, always use the microwave oven fan when cooking on the range. This will help to keep the controller cool and dry. (Samsung's troubleshooting guide says the fan will turn on automatically if the microwave oven gets too warm from cooking underneath it.)

It sounds like you are having difficulty with the bottom switch on your Samsung Model GE0103MB microwave not engaging with the door release button. This can prevent the microwave from functioning properly and could be caused by a few different issues:

1. Make sure that the switch is properly connected to the door release button. The switch may have been installed incorrectly during the repair process, which could prevent it from engaging properly.
2. Check the door release button to ensure that it is not damaged or malfunctioning. The door release button could be preventing the switch from engaging properly.
3. Check the wiring connections to the switch and door release button to ensure that they are secure and not damaged.
4. If you are having difficulty assembling the microwave, I suggest you to try and get the service manual or a diagram of the assembly process for your specific model GE0103MB. You can try searching for it online or contacting Samsung customer service, as they may be able to provide you with the information you need.
5. If the problem persists, you may want to contact a qualified technician to service the microwave and inspect the door switch and door release button.

It's important to note that working on a microwave oven can be dangerous and should only be attempted by someone who is familiar with the inner workings of the device, and have the proper tools and equipment.

Now you know why they were selling it, it doesn't work and needs dealer service! https://www.fixya.com/support/r29874712-repairing_microwave_ovens ..

It will be fine. They aren't made for sustained cooking on high power. Popcorn is dry but oiled, so it gets very hot and burns. You can use the glass carousel plate or replace it. Depending how big the crack is, any water in the crack will finish it off. A new glass tray is $57. A new Microwave the same is $319. Samsung are one of the better makes. https://www.google.com/search?q=samsung+me18h704sfs+replacement+glass+plate ..

Yes Lori, professional repair. Why? https://www.fixya.com/support/r29874712-repairing_microwave_ovens ..

The small plastic plate on the microwaves door with the spring it it needs to be replaced.

E-32 error means you have a wiring or circuit board short. Easier or cheaper to replace without a lot of aggrevation.