20 Most Recent Gestetner DSm615 Digital Imaging System - Page 3 Questions & Answers

sc 569 is the pressure roller contact sensor error Troubleshooting Procedures: 1. Check or replace the harness of the pressure roller contact sensor. 2. Replace the pressure roller contact sensor. 3. Replace the pressure roller contact motor

sc 569 is the pressure roller contact sensor error Troubleshooting Procedures: 1. Check or replace the harness of the pressure roller contact sensor. 2. Replace the pressure roller contact sensor. 3. Replace the pressure roller contact motor

Sc 547 is Zero cross error Troubleshooting : 1. Check the power supply source. 2. Replace the +24V fuse on the PSU. 3. Replace the PSU ( power supply unit)

Sc 547 is Zero cross error Troubleshooting : 1. Check the power supply source. 2. Replace the +24V fuse on the PSU. 3. Replace the PSU ( power supply unit)

password word can be reset in special SP mode as follows: Reset, 1,4,3 press C then hold C special SP mode, go to SP direct 5-846-046 This will rest the Admin password to default

password word can be reset in special SP mode as follows: Reset, 1,4,3 press C then hold C special SP mode, go to SP direct 5-846-046 This will rest the Admin password to default

Hi Hope this helps.The metal gauze filter (see image) behind the input nipple on the drum unit may become blocked with congealed ink deposits causing the ink not to feed at full flow.Strip and clean the blocked gauze filter in the Ink Supply System.

The ID sensors are dirty or transfer belt unit is damaged/dirty/faulty. The ID sensors are below the fusing unit facing down onto the belt. Usually best to remove the fuser unit and the belt unit to get to them with a short brush or unscrew to remove them but be very careful not to damage the transfer belt!

Door switch not working

Clean paper exit feeders

Description. Cutter error The cutter HP sensor does not turn on within 3.0 seconds after the cutter motor turns on .

Your master cutter is jammed clean the Master cutter

Ink pump motor may be not working first you need check your cp is original.. After that remove drum unit disabled the unit and clean ink detection sensor and ink pump motor

E02 Paper Table Drive Failure.The paper height sensor or the table lower limit sensor does not turn on within 7 seconds after the table drive motor turns on. point to check- Paper table drive motor Paper height sensor or table lower limit sensor. Mechanical interference with the paper table drive

SC code:E-21 Paper exit timing sensor remains off E-22 2nd feed timing sensor remains off E-23 Master eject position sensor remains E-24 Feed start timing sensor remains off point to check- Feed start timing sensor dirty sensor or failed, air line to get dust off my first step.

Please check out below link for solution http://www.wic.support/?p=207 01 Error Code on Epson printer LCD tips to fix WIC Reset Utility Reset the...

Ricoh DX4542 JP4500 service manual download