20 Most Recent
Philips Magnavox 50ML8105D 50" HDTV DLP TV - Page 3 Questions & Answers
How to connect a labtop to a Philips projection tv
not easy...most do not support the correct output format....You can howeve buy a converter box from mcm electronics but you will likely be disapointed in the resolution...it takes and HD TV to get decent computer video output..
My tv s
horizontal output and flyback transformer is the usual cause of that symptom. You should be able to get replacements from
www.tvrepairworld.com
Lamp replacement
Its easy...just buy a bulb from sites like
Tv Repair Kits and swap it out. To do that remove the back bulb cover, pull out the bulb box....remove the old bulb and put the new one in.
My 50 inch magnavox takes ten to twelve trys to
Hello,
It's the problem of overheating in the power supply board of the TV.on the power supply board of the TV there are few capacitors and IC.any of this ic is got short or may be weak.so due to this when you start the TV the current passes from electric outlet to the power supply board of TV.but when the current passes from that weak/faulty part at that time current gets stopped or slow and the board overheats and TV shuts off. this is a common problem faced by many other users too.the possible option to solve this issue is to check the power supply board by a meter and continuity tester and replace the faulty component on the board which is short due to which power supply board is getting overheated.its bit technical job but yes its not at all a costly repair to do or get it done by the technician. for required parts it can be easily available from local electronic hardware shop.
Take care in solving the problem.....
My magnavox 37MF321D/37 will not turn on. It
I had the same problem with the blinking green light. These are the parts one the power supply I replace to repair it. note: If the power supply is repaired you will get a solid green light and the backlight will light up almost immediately.
Only 1/3 of my 50" dlp screen lights up
Most likely a issue with the optical light engine--it communicates with the digital board in the set--if it is a even loss (not irregular) it might also be something between light source and mirror--there are some shields that can come loose and block part of the screen that way.
Magnavox 37MF437B/37 keeps blowing fuses
Either a short somewhere---which fuse? The one at the power cord or what?Other possible reason is wrong fuse----many of the fuses in these sets are special-----if you go and buy some Generic ones--hardware store or Radio Shack the fuse even with same amperage/voltage rating may blow at turn on instantly for no reason------
No sound/no picture
well to start the bulb has nothing to do with the sound sounds like the fan might have stopped working and it overheated no good outcome here likly fried it
No picture flashing red light
I think there are far too many of us that have the same issues with this TV and that there is undoubtly something that they should have recalled. I think I may send an email to Phillips/Magnavox I suggest anyone else with same issues do the same.
HAVE DOUBLE PICTURE
Double picture can happen for two reasons. Is it double on TV/Cable or double on all inputs. If it is the TV, try a different input. If it is double on everything you tv is defective and/or broken.
Not finding what you are looking for?