Toshiba DKT-2010H Corded Phone - Answered Questions & Fixed issues

Via the System Administration Mailbox

intercom, #key, 64,22 then press speaker.

Have a look under the phone to see if there are any switches. Normally the is a 3 possition switch for two types of ring tone and a off possition.

what model phone system do you have. Is it a DK or a CTX system.

By dialing intercom #621 and pressing the * key to move cursor left. press pound changes to letters and 0 is toggle. Your manual and good guides are here
http://guides.idacomusa.com/

intercom #673 to lock
intercom #674 to unlock
to overide the code intercom #674 '0000' (4 times zero)

Sounds like the station is in do not disturb mode.Internal, external and transfered calls do not ring but the station can still make calls. there should be a lit button on the set maybe marked do not disturb or DND. press the button again to turn the led off. hope that helps

Do you mean send the call to another phone?
Make sure the line is not on hold (push the caller's line) then push Cnf/Trn, dial the extension you want the call to go to, then hang up.
The person you're sending to will receive that call on their speakerphone button and it will ring in a different tone.

You can get your entire manual here:
http://www.p1bc.com/toshiba/toshiba_dkt_2/DKT2010-H.htm

this is call waiting setting
must disable it from the program..
or may be some body over ride the call to u
contact the phone proviver to disable the setting

which system?
The most popular is the DK system but it came in several revisions.
The primary differences are the way the ports are numbered and several program numbers.
Programming is done from port 005(ext 205).
The sequence of events is:
enter programming mode by pressing "speaker *#*#1*2*3"
enter ringing program
Day ring is "spkr 81 hold"
enter port number of the port you want to ring (example : 007#)
press buttons corresponding to the lines you want to ring then press hold.
To exit programming press"spkr ## hold then spkr ## hold.

What does it say whe you push the message light?

intercom # key 409 then press speaker.

please repost if you still need help.

Hi Daren,
I hope by now someone has helped you, if not please repost and I can help. ....Mike

Try to conf two outside parties with your phone to make sure the phons system will allow tandem trunking. Follow your example by dialing the first party, press conf/transfer, dial the second party, press conf/transfer, then press conf/transfer a third time to add everyone together. I think you are just missing the last step of pressing conf/trans the third time to add the lines together. Good Luck.

This is a very common problem with the Message waiting light, it can be used to turn on other msg waiting lights on other phones, or used to call back the voicemail after a message has been left in your mailbox. What you need to do is cancel the message waiting light, the code is Intercom + #409, then you will hear a studder dial tone, do that code from both phones (ext 11 and ext 24) and it should solve your problem. I would recommend after using the code, follow up with leaving a message in each phones mailbox to turn the light back on and see if then when you press it, it will take you to your mailbox.

I hope this helps, post back if not.

do you have 2 seperate telephone numbers?

When you press any button the speaker will make a quick beep. Is this what you are asking about or are you asking about the DTMF tones when you press a number button 1-9,0,*,#

You can download the manual from the link below: http://www.atsco.info/downloads/CTX%20DKT-IP%20Handset%20User%20Guide.pdf Please update the question & let us know if the information given was useful to you - Good Luck!