Top 20
Milwaukee Tool Case Heat Gun Questions & Answers
Deisel fuel getting to injector pump. Feul also
you prabably have an airlock inside the injector lines.
Disconnect two lines and crank again,this will push out the air so fuel can get to the injectors.once the fuel comes out reconnect the lines and it should start
Front axle
replace the wheel baring or the hole wheel,lubricate the wheel-shaft.
I have MXM 155 pro.
the problems will be expensive as there are shafts bearings and bushes that will all be damaged from the lack of oil. I would be making enquiries at the service centre as to what sort of workshop insurance they have to cover that sort of error as it should have had oil levels checked before it was released to you.
I NEED THE VALVE CLEARANCE
Hi gabriele_vig,
Welcome to fixya!
The clearance for the inlet valves is 0.010". The exhaust valve clearance is .0.12".
Please place a vote when you accept this solution. Thanks,
Handie Andie
I am looking for a
try contacting CASE on line customer service and enquiring as to where you can get what you require.
I have a 1845C case
Hi,
Sorry, but there is no easy way to do that...
You will need to get it somewhere that you can jack that side up and take the wheels off to be able to get it fixed right...even then it can be a pain in the rear...
Check the chain.. you may need to take a full link out and put a half link in there to get the chain tighter...
heatman101
Not finding what you are looking for?