Top 20
LG WD-1280FHD Front Load Washer Questions & Answers
Lg Washing machine. WD11020D will not open.
door lock sounds like its broken, you will need to remove the two screws on the back of washer top and remove the top. (power off) now as you look at washer from the front you will see a round object with a pipe. remove the pipe and see if the door opens. this is just to check to see if its this part stopping the door to be open, you are going to need to use a flat blade to push the pin in the lock you should see the pin as this stops the door from being open. the part looks like this https://www.ebay.com/i/253266384384?rt=nc if the door is slammed or banged, it can damage the lock, easy to replace when the you can open the door. wiring plug only fits one way.
Hi I have an LG
Hi Matt
Ask your mechanic to change the door hingle only. Dont change the complete door.
How do i repair start/pause button
you dont try to repair it if you do it your board may be comletely or partially gets damaged which may cause malfunctioning so u better contact to your near lg store
Wont start machine error come up
Door open error code can also be displayed as "dOE"
On non-display panel models this fault code is denoted by the light for the door lock being lit or flashing.
- Check door is closed correctly and latched
- Check door handle for damage or wear
- Check door safety lock if inoperative replace door lock
- Check door lock wiring
- If there is a clicking sound once or twice when the Start/Pause button is pressed the main control board may be faulty
Washing machine
I see a little confusion here...there is LG WD-1280FHD which is the MODEL number, WD= washer-dryer, LG=Life's (not so) Good. The "F" is for Front Load... HD for dryer Heated Dryer. The numbers correlate to date and assembly plant location. IDK this other number your showing is a Part Number If you need further help, reach me via phone at
https://www.6ya.com/expert/steven_b77d19396bfe2249
Washing machine doesnt wash
Fault code 130 means the RPS (rotor position sensor) is not sending correct signals to the control board. The RPS is a small electronic device mounted on top of the motor copper stator. Either the wiring plug attached to the RPS has corroded the contacts or the RPS needs replacing. You will have to lie the machine down on front face to access the motor. Unscrew the centre bolt and remove the outer rotor bowl, then loosen the 4 hex. head bolts holding the stator about half way. Pull stator down so you can remove the wiring plug from RPS. Check for corrosion. If no corrosion then remove & replace the RPS.
LG wd 1460FD is not loading water
Try this.
reset machine. start a quick cycle. Once the pump starts, open door and add 2-4 cups of water. close door.
If machine starts to work the the water inlet valve needs to be replace.
I have a LG WD 1238C Front Loader Washing Machine
Remove power for some time , allow the power to drain off the memory and see if the display is clear. If not hold the start button and switch on power. Check the inlet and drain filter , free water flow, if not remove and clean.
Gets code de
Door switch assembly is faulty, check and replace if necessary.
Not finding what you are looking for?