20 Most Recent LG DLE3777 Electric Dryer Questions & Answers


look for a restricted vent . and a cold floor or room . this would cause condensation and would leak from inside / causing leakage on floor in or around the dryer .. hope this helps . pls leave feed back .. mm

LG DLE3777... • Answered on Mar 30, 2021


You posted in 2013, I just bought my in 2019 and it still sounds like a chug chug train. Annoying but sir Topham Hatt may have a fix one day.

LG DLE3777... • Answered on Jan 28, 2019


if it has continuity it's good and isn't the problem,if the dryer starts and stops running after a minute you could have a bad computer board,when it stalls try tapping on the board and see if it starts,also unplug it and look at the board you might see something cooked on it or a soldier joint melted.

LG DLE3777... • Answered on Dec 26, 2017


Check out videos on repairclinic.com or appliancepartspros.com or YouTube.com

LG DLE3777... • Answered on Aug 05, 2017


Google the make and model see if you can down load a manual for this which will give you details on how to put the seal back, but not with a hammer .

LG DLE3777... • Answered on Apr 13, 2017


Hello Mary; My name is Peter. I am a retired field service appliance technician. Both LG & Samsung appliances are a service technicians nightmare. They have the highest service call rate, the most expensive parts and take the most time to access and repair parts. I will give Samsung a thumbs up on televisions and stereo's. It would be nice if consumer reports would survey field service technicians rather than owners and get the real story. Believe me you do not want to disassemble. You are going to end up calling a service company to put it back together and get a $250.00-$300.00 bill. Ok, what can you do? Air flow blows 95% of the lint out the connection to the outside air discharge behind your dryer. 1.) Pull your dryer out to the point that you can get behind it. 2.) Unplug your dryer. 3.) Hot air distribution manifold - There are several screws holding this on. There are no hot electrical components to be concerned with. Remove this. 25706565-0y12ph2q2eyplwuhbpotrs5a-2-0.jpg In the bottom rounded part is where you get plugged up. Clean this out. 4.) Hot air discharge at the wall - Usually, the connector vent hose is held on with band clamps. In this case you need a flat heat screw driver to loosen and remove the vent hose. 5.) With a vacuum cleaner hose, vacuum out the hole in the wall as far as you can reach. Then, vacuum out the air discharge as far as you can reach. The hot air blower wheel in in the front of your dryer. 6.) Before reinstalling the hot air distribution manifold and connecting the out side air duct. Plug your unit in and turn your dryer on and run for 5 minutes to blow out excess lint. The hot air distribution manifold and the outside air duct create a back pressure. This way your blower wheel will run full open.

LG DLE3777... • Answered on May 21, 2015


check you entire vent system and make sure there is a clear airflow all the way to the outside. A simple test is disconnecting the vent hose and letting the air flow into the open room. If works OK, you definitely have an airflow problem.

LG DLE3777... • Answered on Feb 02, 2015


I have been using an LG domestic dryer in a commercial application (motel) for 5 years and the only problem has been a lint build up inside the dryer because of an improper vent installation. The problem is likely in the dryer drum motor, it runs for a short time heats up because of bad motor bearings, improper motor cooling or bad drum bearings (motor drives the drum) increased heat = increased amperage= blown fuse. Motor should go out on overload but it may blow a fuse first. Is the fuse in the electrical panel or in the dryer? Try turning the dryer drum by hand and check for resistance, there shouldn't be much. The motor needs to cool so pull the dryer panels apart and vacuum the inside first and make sure the motor and interior has been thoroughly cleaned. Try this for a quick fix first.

LG DLE3777... • Answered on Feb 01, 2015


The thermostats (outlet and on element case) can still allow the heat to go to high, restricted airflow will also cause them to go.

LG DLE3777... • Answered on Feb 01, 2015


It could still be grounded/shorted, the elements will weld themselves to their case or themselves. Continuity should be 8-20 ohms.

LG DLE3777... • Answered on Feb 01, 2015


It could be the high limit switch is open. Most of these are non resettable and have to be replaced. Check vent piping and filters for lint that may be clogging the vent system and causing the overheating. Replace the high limit. If that does not solve the problem the element may be burned out. Hope this helps Bob

LG DLE3777... • Answered on Dec 17, 2014


Short in board or behind. Do not run the dryer. Remove back cover and look for obvious black marks. Replace as necessary. Dryers get banged around and hopefully it is an easy find. It could be the board itself. I'll hope for a small short that can be fixed with electric tape.

LG DLE3777... • Answered on Jan 13, 2014


Did you ever find out what was the problem? Mine does the exact same thing.

LG DLE3777... • Answered on Nov 03, 2013

Not finding what you are looking for?
LG DLE3777 Electric Dryer Logo

105 questions posted

Ask a Question

Usually answered in minutes!

Top LG Dryers Experts

Dan Webster
Dan Webster

Level 3 Expert

8221 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1482 Answers

Are you a LG Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

LG Dryers

  • LG Dryers

Most Popular Question

dryer door opens in middle drying

  • Dryers
Loading...