20 Most Recent
LG DLG5932W Gas Dryer - Page 5 Questions & Answers
NOT HEATING
[email protected]
Hi,
If you are having problems with your gas dryer not heating the most common problem is that the ignitor goes bad. Even though it glows sometimes it is still not working properly.
if you dryer is gas check out this gas no heat tip....
If you have an electric dryer, you can have many different things that can go wrong causing the dryer not to heat.
check out this electric no heat tip...
heatman101
Dryer will not get hot
Tromm LG DLG5988 gas dryer
Heater not turning on
Gas light on
Cooling light on at the same time
Heat Sensor light on
I checked gas it is on and flowing through the pipe up to the dryer
Can't find igniter, reset switch or fuses on the dryer
Lg dryer not getting hot
can be many problems; gas valve, igniter, thermostats. you will need a qualified tech to check out. of course, check the exhaust hose and damper door for cleanliness.
My Drier shows no flow
Yes, everything in this is machine is covered under warranty.
Actually, there's no flow sensor in this machine. Only the temperature of the air is monitored by means of the thermistor and the cycling thermostat both located on the blower housing. The control deduces that there's an air flow restriction when there's an extreme air temperature passing through these parts.
The heat goes on then off.. then on off a little
Bypass the high-limit thermostat and the thermal cut-off on the burner funnel to isolate the flame sensor and the igniter. Make sure
then that igniter is positioned in such a way that it is dipped into the
burner flame to keep it hot and its resistance low. Keeping the igniter
resistance low applies full voltage to the secondary valve and keeps it
open. It will cool down then eventually shut the secondary valve off if
it's not kept heated by the burner flame. The heat from the igniter
also keeps the flame sensor contacts open to allow immediate re-ignition
after the cycling thermostat cycles off.
Make sure the flame sensor is installed in such a way that the sensor is
aligned with the slot on the burner funnel for the flame to heat it up.
Replace the flame sensor if it is
properly installed and the igniter is installed and working properly.
Premature closing of the flame sensor contacts means it is bad.
Ijwant to dry my cloth
You should empty the lint filter. The lint filter catches all the lint from your clothes and will need cleaned occassionally. I clean my lint filter after every load. Towels usually clog the filter faster than other clothes.
My lg tromm DLG69885 gas dryer is not heating; oth...
Hi,
I am using LG Tromm DLE2514 washer dryer. It 's running but didn't dried the clothes. I clean it's lint but still it's not working. The one thing i notice now is it's drying light is blinking and cooling light is turn on all the time during the cycle. So what's the problem with my dryer?
Seems to work but doesnt dry
check the entire exhaust vent wok
a moister sensor detects any built up of lint and shuts the burner off to prevent fires starting
Not finding what you are looking for?