20 Most Recent Moen 1 Handle Lever Shower Faucet With POSI Valve NI - Page 8 Questions & Answers

turn off water Remove set screw on side of handle. once the handle is removed try to realign. if that does not work remove the cartridge nut and reposition the cartridge as to set properly. the cartridge normally has a tab on it set in the groove of the valve body.

Moen has great customer support. Yes, you should be able too. Call 1-800-buy-moen and they will talk you thru it on the phone.

If you have removed wall tube and the retaining nut sleeve and any handle adapters, the cartage should just pull out. grip with vise grips and attempt to pull while wiggling and turning .

inside the cartridge is a pressure balance cylinder. If it does not side back and forth with a clicking sound when shaken the cylinder needs to be unjammed. carefully push the brass handle head backwards exposing the inside center out of the back of the of the cartridge. use an ice pick into the side of the inner cartridge to wedge the inner balancer to move. once loose, reassemble. If you cannot get the balancer loose, replace the cartridge.

Yes that fits the symptom.

what the handles are attached to the cartridge just replaces the old washer set up

The only reasons I can think of are two: 1. Personal safety. If someone gets their hand(s) burned using what they think is the cold water, you can be held liable in court. 2. Building codes. You may have issues when time to sell if an inspector catches the problem then.

Look underneath the faucet to see if something stored in the cupboard is tangled up in the hose.

I don't know specifically, but there are several good videos on youtube installing Moen products. I hope they can help you. A friend of mine replaced his Moen Bathtub fittings and was impressed with their customer service. They can be reached at 1 (800) 289-6636

You can purchase from Moen directly here is the link to the replacement parts for you :) http://www.moen.ca/replacement-parts

To install a drain through the DIY technique can be tough, provided you have all the tools and equipment to perform the task. However, do not take risk with such a volatile thing and instead call a professional plumber, who are the expertise and the tools to install your drain. Residentail plumbers are always very handy with general plumbing, drain line and sewer line installation, repair and replacement.

How do I remove the faucet Moen model 87787 to place O-rings?

The most likely cause is the shutoff valve under the sink has lost part of the rubber washer and has traveled into the faucet. Faucets don't get airlocks

some new faucets come with there on supply lines when you tighten one will twist at the top near the faucet look under the sink to see if this has happened. i've had it happen not long ago

If you take the handle off there is a small black nut that holds the cartridge in a lot of times that nut comes loose from the factory just snug that nut up with a pair of pliers if that does not work you need a new cartridge the cartridges are free if you call 1 800buyMoen just tell them your model number and what's going on they will send you the new parts at no charge

Loosen the central nut

The u shaped bracket slides on and off try using a flat head screwdriver to pry it off

NO.