20 Most Recent Makita 7 1/4" Circular Saw 5007NB - Page 8 Questions & Answers

replace brushes

Bad drive gear http://www.toolpartsdirect.com/saw/jig-saw.html?brand=Makita&ad=7871623319 Makita Jig Saw Parts Tool Parts Direct

Where did the petrol come out from? The tank lid or the muffler or somewhere else?

so,remember that and move the wood to the left or find someone that knows how to operate a saw

you are cutting to the right,the mark on the saw is only a reference,it is up to you to figure where to saw

It's on the righthand side of the saw at the hinge area in the back. If that is unlocked then it could be the guard linkage hanging up.

lots of sparks means your brushes are used up, broken or stuck. Replace them. If that is not the problem, it could be you over heated the motor, very difficult to do, and the motor is about to die. Check brushes first. You can tell by examining your graphite brushes. Use a straight screw driver and unscrew the black cap that holds the brushes in place.

Maybe you accidently pushed the safety lock on it. Most power tools do come with a safety lock. Check your owner's manual and see where to unlock it.

The nut is not on the bottom, but under the snapout kerf plates. You remove the plastic kerf plates to access the bolt. Once you remove the nut the turntable will lift straight up and off. Check the stainless steel wear plate at the rear for burrs or wear. Do not use oil or wd40 etc - it will collect sawdust and cause problems down the road. I recommend a pure silicone spray that will dry completely and provide lubrication.

Makitatools.com is a company website, look under support,tablesaws, manuals. Good luck

Try that robert!!>> http://www.rkm.com.au/calculators/calculator-circle-sphere.html